| nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
| 1 |
Air-bearing design and flying characteristics of flexible optical head slider combined with visible laser light guide
|
Hirota, T.
|
|
2002
|
8 |
2-3 |
p. 155-160
|
artikel
|
| 2 |
A novel contact slider/gimbal to raise recording density in flexible disk drives
|
Ryoson, H.
|
|
2002
|
8 |
2-3 |
p. 188-193
|
artikel
|
| 3 |
A push–pull multi-layered piggyback PZT actuator
|
Nakamura, S.
|
|
2002
|
8 |
2-3 |
p. 149-154
|
artikel
|
| 4 |
Comparison of PMMA and SU-8 resist moulds for embossing of PZT to produce high-aspect-ratio microstructures using LIGA process
|
Schneider, A.
|
|
2002
|
8 |
2-3 |
p. 88-92
|
artikel
|
| 5 |
Critical and flutter speeds of optical disks
|
Lee, S.-Y.
|
|
2002
|
8 |
2-3 |
p. 206-211
|
artikel
|
| 6 |
Deep lithography with a low energy synchrotron source: fabrication of X-ray refractive single lenses
|
Zhang, Y.
|
|
2002
|
8 |
2-3 |
p. 99-101
|
artikel
|
| 7 |
Design and analysis of dual-stage servo system for high track density HDDs
|
Suh, S.-M.
|
|
2002
|
8 |
2-3 |
p. 161-168
|
artikel
|
| 8 |
Design and testing of track-following controllers for dual-stage servo systems with PZT actuated suspensions
|
Li, Y.
|
|
2002
|
8 |
2-3 |
p. 194-205
|
artikel
|
| 9 |
Design of hydrodynamic bearings for high-speed HDD
|
Asada, T.
|
|
2002
|
8 |
2-3 |
p. 220-226
|
artikel
|
| 10 |
Development of novel PZT thin films for active sliders based on head load/unload on demand systems
|
Tagawa, N.
|
|
2002
|
8 |
2-3 |
p. 133-138
|
artikel
|
| 11 |
Editorial
|
Bley, Peter
|
|
2002
|
8 |
2-3 |
p. 73
|
artikel
|
| 12 |
Electrical bottom side contacting of electromechanical LIGA-structures by vias and screen printing
|
Ruzzu, A.
|
|
2002
|
8 |
2-3 |
p. 113-115
|
artikel
|
| 13 |
Exposure of photosensitive glasses with pulsed UV-laser radiation
|
Brokmann, U.
|
|
2002
|
8 |
2-3 |
p. 102-104
|
artikel
|
| 14 |
Feedstock development for micro powder injection molding
|
Merz, L.
|
|
2002
|
8 |
2-3 |
p. 129-132
|
artikel
|
| 15 |
MEMS-based accelerometers use in Hard Disk Drives
|
Oboe, R.
|
|
2002
|
8 |
2-3 |
p. 174-181
|
artikel
|
| 16 |
Micromolded easy-assembly multi fiber connector: RibCon®
|
Wallrabe, U.
|
|
2002
|
8 |
2-3 |
p. 83-87
|
artikel
|
| 17 |
Microscreen-based replication of electroforming micromolds
|
Domeier, L. A.
|
|
2002
|
8 |
2-3 |
p. 78-82
|
artikel
|
| 18 |
Moving mask deep X-ray lithography system with multi stage for 3-D microfabrication
|
Tabata, O.
|
|
2002
|
8 |
2-3 |
p. 93-98
|
artikel
|
| 19 |
Optical recording system using an integrated solid immersion lens
|
Song, T. S.
|
|
2002
|
8 |
2-3 |
p. 169-173
|
artikel
|
| 20 |
Production of metallic high aspect ratio microstructures by microcasting
|
Baumeister, G.
|
|
2002
|
8 |
2-3 |
p. 105-108
|
artikel
|
| 21 |
Quality based design approach for a single crystal silicon microactuator using DOE technique and response surface model
|
Chen, S.
|
|
2002
|
8 |
2-3 |
p. 182-187
|
artikel
|
| 22 |
Quasi-static and cyclic testing of specimens with high aspect ratios produced by micro-casting and micro-powder-injection-moulding
|
Auhorn, M.
|
|
2002
|
8 |
2-3 |
p. 109-112
|
artikel
|
| 23 |
Readout signal evaluation of optical flying head slider with visible light-wave guide flexure
|
Ohkubo, T.
|
|
2002
|
8 |
2-3 |
p. 212-219
|
artikel
|
| 24 |
Swelling of PMMA-structures in aqueous solutions and room temperature Ni-electroforming
|
Ruzzu, A.
|
|
2002
|
8 |
2-3 |
p. 116-119
|
artikel
|
| 25 |
Swing-arm-type PZT dual actuator with fast seeking for optical disk drive
|
Cho, W.-I.
|
|
2002
|
8 |
2-3 |
p. 139-148
|
artikel
|
| 26 |
The influence of X-ray fluorescence on LIGA sidewall tolerances
|
Griffiths, S. K.
|
|
2002
|
8 |
2-3 |
p. 120-128
|
artikel
|
| 27 |
Two-dimensional metallic photonic band-gap crystals fabricated by LIGA
|
Katsarakis, N.
|
|
2002
|
8 |
2-3 |
p. 74-77
|
artikel
|
Tijdschrift beschrijving