nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
Analytical investigation of porous pin fins with variable section in fully-wet conditions
|
Vahabzadeh, A. |
|
2015 |
5 |
C |
p. 1-12 12 p. |
artikel |
2 |
A new method for non-Fourier thermal response in a single layer skin tissue
|
Kundu, Balaram |
|
2015 |
5 |
C |
p. 79-88 10 p. |
artikel |
3 |
A numerical study on helical vortices induced by a short twisted tape in a circular pipe
|
Liu, Wen |
|
2015 |
5 |
C |
p. 134-142 9 p. |
artikel |
4 |
A research on thermoelectric generator's electrical performance under temperature mismatch conditions for automotive waste heat recovery system
|
Tang, Z.B. |
|
2015 |
5 |
C |
p. 143-150 8 p. |
artikel |
5 |
A Taguchi approach for optimization of flow and geometrical parameters in a rectangular channel roughened with V down perforated baffles
|
Chamoli, Sunil |
|
2015 |
5 |
C |
p. 59-69 11 p. |
artikel |
6 |
Beneficial design of unbaffled shell-and-tube heat exchangers for attachment of longitudinal fins with trapezoidal profile
|
Kundu, Balaram |
|
2015 |
5 |
C |
p. 104-112 9 p. |
artikel |
7 |
Chemical non-equilibrium flow analysis of H2 fueled scramjet nozzle
|
Huang, Yue |
|
2015 |
5 |
C |
p. 89-97 9 p. |
artikel |
8 |
Corrigendum to “Study of forced convection nanofluid heat transfer in the automotive cooling system” [Case Stud. Therm. Eng. 16 (2014) 50–61]
|
Hussein, Adnan M. |
|
2015 |
5 |
C |
p. 113- 1 p. |
artikel |
9 |
Design and analysis of a cogeneration plant using heat recovery of a cement factory
|
Pradeep Varma, G.V. |
|
2015 |
5 |
C |
p. 24-31 8 p. |
artikel |
10 |
Enhance heat transfer in the channel with V-shaped wavy lower plate using liquid nanofluids
|
Abed, Azher M. |
|
2015 |
5 |
C |
p. 13-23 11 p. |
artikel |
11 |
Enhancement heat transfer characteristics in the channel with Trapezoidal rib–groove using nanofluids
|
Al-Shamani, Ali Najah |
|
2015 |
5 |
C |
p. 48-58 11 p. |
artikel |
12 |
Explicit representation of the implicit Colebrook–White equation
|
Rollmann, P. |
|
2015 |
5 |
C |
p. 41-47 7 p. |
artikel |
13 |
Heat transfer and pressure drop comparison of louver- and plain-finned heat exchangers where one fluid passes through flattened tubes
|
Gorman, J.M. |
|
2015 |
5 |
C |
p. 122-126 5 p. |
artikel |
14 |
Investigations for effect of Al2O3–H2O nanofluid flow rate on the efficiency of direct absorption solar collector
|
Gupta, Hemant Kumar |
|
2015 |
5 |
C |
p. 70-78 9 p. |
artikel |
15 |
Molecular dynamics simulation on flow behaviors of nanofluids confined in nanochannel
|
Cui, Wenzheng |
|
2015 |
5 |
C |
p. 114-121 8 p. |
artikel |
16 |
Performance modeling of industrial gas turbines with inlet air filtration system
|
Effiom, Samuel O. |
|
2015 |
5 |
C |
p. 160-167 8 p. |
artikel |
17 |
Prediction of small spark ignited engine performance using producer gas as fuel
|
Homdoung, N. |
|
2015 |
5 |
C |
p. 98-103 6 p. |
artikel |
18 |
Prototype implementation and experimental analysis of water heating using recovered waste heat of chimneys
|
Khaled, Mahmoud |
|
2015 |
5 |
C |
p. 127-133 7 p. |
artikel |
19 |
Study on effectiveness of continuous solar dryer integrated with desiccant thermal storage for drying cocoa beans
|
Dina, Sari Farah |
|
2015 |
5 |
C |
p. 32-40 9 p. |
artikel |
20 |
Water solar distiller productivity enhancement using concentrating solar water heater and phase change material (PCM)
|
Chaichan, Miqdam T. |
|
2015 |
5 |
C |
p. 151-159 9 p. |
artikel |