Digital Library
Close Browse articles from a journal
     Journal description
       All volumes of the corresponding journal
         All issues of the corresponding volume
                                       All articles of the corresponding issues
 
                             18 results found
no title author magazine year volume issue page(s) type
1 Analysis of temporal firing patterns of primary afferent C-fibers for different sensations in mice Cho, Kyeongwon
2017
18 5 p. 739-745
article
2 Control and measurement of doctoring angle at deformed state in doctoring apparatus for printed electronics Jeon, Sung Woong
2017
18 5 p. 633-639
article
3 Development of real-time gait phase detection system for a lower extremity exoskeleton robot Lim, Dong-Hwan
2017
18 5 p. 681-687
article
4 Deviation calculation and analysis of tooth surfaces of conjugate-curve gear drive Liang, Dong
2017
18 5 p. 689-696
article
5 Dielectrophoretic sensitivity analysis of cell characterization Lee, Hyun-Boo
2017
18 5 p. 747-754
article
6 3D multi-nozzle system with dual drives highly potential for 3D complex scaffolds with multi-biomaterials Chen, Zhichao
2017
18 5 p. 755-761
article
7 Effect of substrate bias on the tribological behavior of ta-C coating prepared by filtered cathodic vacuum arc Ean, Yeoh Chin
2017
18 5 p. 779-784
article
8 Effect of vibration transmission direction in ultrasonic thermoforming on the formability of micro-corrugations Bae, Hojin
2017
18 5 p. 697-703
article
9 Electronic part obsolescence forecasting based on time series modeling Ma, Jungmok
2017
18 5 p. 771-777
article
10 Fracture behavior of adhesive interface at TDCB aluminum foam specimen with the type of Mode III Lee, Jung Ho
2017
18 5 p. 705-710
article
11 Improving performance of cable robots by adaptively changing minimum tension in cables Abdolshah, Saeed
2017
18 5 p. 673-680
article
12 Increasing payload capacity of wearable robots employing linear actuators and elastic mechanism Choo, Junghoon
2017
18 5 p. 661-671
article
13 Path smoothing for five-axis machine tools using dual quaternion approximation with dominant points Zhao, Xin
2017
18 5 p. 711-720
article
14 Precision measurement of Z-slide vertical error motion of an ultra-precision lathe by using three-probe method Niu, Zengyuan
2017
18 5 p. 651-660
article
15 Processing errors in an on-machine measurement method based on the adaptive triangular mesh Shi, Wu
2017
18 5 p. 641-650
article
16 Structural analysis of automotive cowl parts considering welding residual stress Bang, Hee-Seon
2017
18 5 p. 729-737
article
17 Study on the design parameters of a low speed coupling of a wind turbine Kang, Jong-Hun
2017
18 5 p. 721-727
article
18 Temperature-dependent mechanical properties of ABS parts fabricated by fused deposition modeling and vapor smoothing Zhang, Sung-Uk
2017
18 5 p. 763-769
article
                             18 results found
 
 Koninklijke Bibliotheek - National Library of the Netherlands