| nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
| 1 |
A 3D numerical analysis using phase change material for cooling circular light emitting diode
|
Ben Hamida, Mohamed Bechir
|
|
|
43 |
C |
p.
|
artikel
|
| 2 |
A heat transfer model for global warming
|
Beans, E. William
|
|
|
43 |
C |
p.
|
artikel
|
| 3 |
ANFIS based effectiveness and number of transfer units predictions of MWCNT/water nanofluids flow in a double pipe U-bend heat exchanger
|
Sundar, L. Syam
|
|
|
43 |
C |
p.
|
artikel
|
| 4 |
A novel method of variable flow operation in district cooling system: A case study
|
Zhang, Wei
|
|
|
43 |
C |
p.
|
artikel
|
| 5 |
A numerical investigation of droplet bouncing behaviors on the superhydrophobic surfaces with different micro-structures
|
Lu, Sirui
|
|
|
43 |
C |
p.
|
artikel
|
| 6 |
A predictive model of frost formation on leaf surface and estimation of frost amount
|
Song, Huan
|
|
|
43 |
C |
p.
|
artikel
|
| 7 |
A renovated Jaffrey-Hamel flow problem and new scaling statistics for heat, mass fluxes with Cattaneo–Christov heat flux model
|
Rehman, Sohail
|
|
|
43 |
C |
p.
|
artikel
|
| 8 |
Aspects of Cattaneo-Christov heat flux in nonlinear radiative ternary, hybrid, and single mass diffusion past stretching surface; A comparative study
|
Fatima, Nahid
|
|
|
43 |
C |
p.
|
artikel
|
| 9 |
A two-phase simulation for analyzing the hydraulic-thermal performance of Cu–Water nanofluid within a tube enhanced with W- and C-shaped ribs
|
Zhou, Yuan
|
|
|
43 |
C |
p.
|
artikel
|
| 10 |
Comparative analysis of sizing procedure for cooling and water heating cascade heat pump applied to a residential building
|
Kim, Beom-Jun
|
|
|
43 |
C |
p.
|
artikel
|
| 11 |
Comparative investigation of charging performance in shell and tube device containing molten salt based phase change materials for thermal energy storage
|
Li, Chuan
|
|
|
43 |
C |
p.
|
artikel
|
| 12 |
Comparative studies on the combustion characteristics of electrolytes and carbonate mixed solvents with flame retardant additives under low pressures
|
Huang, Qiurui
|
|
|
43 |
C |
p.
|
artikel
|
| 13 |
Computational analysis of MHD M g O − water nanofluid flow inside hexagonal enclosure fitted with fins
|
Yasmin, Sumeira
|
|
|
43 |
C |
p.
|
artikel
|
| 14 |
Corrigendum to “Heat and mass transfer analysis of non-Newtonian power-law nanofluid confined within annulus enclosure using Darcy-Brinkman-Forchheimer model” [Case Stud. Therm. Eng. 40 (2023) 102569 CSITE-D-22-02293]
|
Abderrahmane, Aissa
|
|
|
43 |
C |
p.
|
artikel
|
| 15 |
Daily variation of ground radiation in unshaded and shaded environments and the effect on mean radiant temperature
|
Fang, Zhaosong
|
|
|
43 |
C |
p.
|
artikel
|
| 16 |
Demonstrating the significance of radiant energy exchange during metal dust combustion
|
Jones, Harrison
|
|
|
43 |
C |
p.
|
artikel
|
| 17 |
Deposition characteristics of particles in backward-facing step flow and a radiant syngas cooler
|
Zhang, Yan
|
|
|
43 |
C |
p.
|
artikel
|
| 18 |
Double diffusion in a porous medium of MHD Maxwell fluid with thermal radiation, heat generation and chemical reaction
|
Sudarmozhi, K.
|
|
|
43 |
C |
p.
|
artikel
|
| 19 |
Double-diffusive magneto-natural convection of nanofluid in an enclosure equipped with a wavy porous cylinder in the local thermal non-equilibrium situation
|
Tayebi, Tahar
|
|
|
43 |
C |
p.
|
artikel
|
| 20 |
Drying kinetics of paddy drying with graphene far-infrared drying equipment at different IR temperatures, radiations-distances, grain-flow, and dehumidifying-velocities
|
Du, Yuanjie
|
|
|
43 |
C |
p.
|
artikel
|
| 21 |
Effect of design parameters on passive control of heat transfer enhancement phenomenon in heat exchangers–A brief review
|
Ali, Mohamed R.
|
|
|
43 |
C |
p.
|
artikel
|
| 22 |
Effect of surfaces roughness of a staggered tube bank in cross flow with air on heat transfer and pressure drop
|
Karali, Mohamed A.
|
|
|
43 |
C |
p.
|
artikel
|
| 23 |
Effects of inflow parameters on thermal protection and drag reduction characteristics for hydrocarbon fueled supersonic film with combustion
|
Zuo, Jingying
|
|
|
43 |
C |
p.
|
artikel
|
| 24 |
Experimental and numerical investigation on combustion performance of C shape burner in 3 MW boiler
|
Han, Baoju
|
|
|
43 |
C |
p.
|
artikel
|
| 25 |
Experimental and numerical study of the PVT design impact on the electrical and thermal performances
|
Touti, Ezzeddine
|
|
|
43 |
C |
p.
|
artikel
|
| 26 |
Experimental assessment and modeling of solar air heater with V shape roughness on absorber plate
|
Kumar, Rahul
|
|
|
43 |
C |
p.
|
artikel
|
| 27 |
Experimental investigation of bimetallic nanoparticles heat transfer characteristics in automotive radiators
|
Arbak, Altay
|
|
|
43 |
C |
p.
|
artikel
|
| 28 |
Ground temperature distribution and evolution of Lanzhou subway in the Chinese Loess Plateau
|
Zhu, Jianghong
|
|
|
43 |
C |
p.
|
artikel
|
| 29 |
Group performance of multiple series-connected energy piles under thermal loading
|
Kong, Gangqiang
|
|
|
43 |
C |
p.
|
artikel
|
| 30 |
Heat and mass transfer analysis for MHD bioconvection peristaltic motion of Powell-Eyring nanofluid with variable thermal characteristics
|
Iqbal, J.
|
|
|
43 |
C |
p.
|
artikel
|
| 31 |
Heat transfer analysis of impinging flames using field synergy principle
|
Zhen, H.S.
|
|
|
43 |
C |
p.
|
artikel
|
| 32 |
Heat transfer characteristics of a water heater operating on natural gas and cofiring with pulverized rumen contents
|
Colorado, A.
|
|
|
43 |
C |
p.
|
artikel
|
| 33 |
Influence of pressure on the circumferential diffusion characteristics of fuel vapor and combustion performance in a pressurized burner
|
Liu, Li
|
|
|
43 |
C |
p.
|
artikel
|
| 34 |
Innovative modeling and simulation of membrane-based dehumidification and energy recovery equipment
|
Gao, Zhiming
|
|
|
43 |
C |
p.
|
artikel
|
| 35 |
In situ U-value measurement of building envelopes through continuous low-cost monitoring
|
Mobaraki, Behnam
|
|
|
43 |
C |
p.
|
artikel
|
| 36 |
Liquid metal-based elastomer heat conduction enhancement enabled by stretching
|
Zhang, Rui
|
|
|
43 |
C |
p.
|
artikel
|
| 37 |
Magneto-thermal convection in partially heated novel cavity with multiple heaters at bottom wall: A numerical solution
|
Fatima, Nosheen
|
|
|
43 |
C |
p.
|
artikel
|
| 38 |
Mathematical modeling and experimental validation of bifacial photovoltaic–thermal system with mirror reflector
|
Mustapha, Muslizainun
|
|
|
43 |
C |
p.
|
artikel
|
| 39 |
Optimal design of thermal control system for space optical remote sensor based on NSGA-II and opto-mechanical-thermal integration analysis
|
Yuan, Zhipeng
|
|
|
43 |
C |
p.
|
artikel
|
| 40 |
Reduced-scale experimental investigation on flow field characteristics of exhaust hood of double helix lifting transportation equipment in an industrial plant
|
Liu, Yanghao
|
|
|
43 |
C |
p.
|
artikel
|
| 41 |
Study of thermal variation in a longitudinal exponential porous fin wetted with TiO 2 − SiO 2 / hexanol hybrid nanofluid using hybrid residual power series method
|
Abdulrahman, Amal
|
|
|
43 |
C |
p.
|
artikel
|
| 42 |
Study on the vertical oscillatory gas-liquid two-phase flow and heat transfer characteristics
|
Huang, Yuqi
|
|
|
43 |
C |
p.
|
artikel
|
| 43 |
Study on typical temperature effect mechanism of multi-component coal during low-temperature thermal expansion
|
Cong, Yuzhou
|
|
|
43 |
C |
p.
|
artikel
|
| 44 |
Testing a stepped solar still with different sand beds and reflectors
|
Atteya, T.E.M.
|
|
|
43 |
C |
p.
|
artikel
|
| 45 |
The Cheng-Minkowycz problem for quadratic convective and radiative heat transfer in a nanofluid saturated porous medium: A revised model
|
Rana, Puneet
|
|
|
43 |
C |
p.
|
artikel
|
| 46 |
The critical location for thermal radiation disaster in personnel evacuation of rack railway tunnel fires under the large longitudinal slope
|
Xu, Pai
|
|
|
43 |
C |
p.
|
artikel
|
| 47 |
Thermal analysis and entropy generation of Darcy-Forchheimer ternary nanofluid flow: A comparative study
|
Chen, Hui
|
|
|
43 |
C |
p.
|
artikel
|
| 48 |
Thermal degradation of KN90 gauze mask rope waste: Thermogravimetric and thermodynamic analyses, kinetic modeling and volatile products
|
Li, Quanwei
|
|
|
43 |
C |
p.
|
artikel
|
| 49 |
Thermal evaluation of a room coated by thin urethane nanocomposite layer coating for energy-saving efficiency in building applications
|
Azemati, AliAkbar
|
|
|
43 |
C |
p.
|
artikel
|
| 50 |
Thermal management of metal hydride hydrogen storage tank coupled with proton exchange membrane fuel cells
|
Tong, Liang
|
|
|
43 |
C |
p.
|
artikel
|
| 51 |
Thermal performance investigation of double pipe heat exchanger embedded with extended surfaces using nanofluid technique as enhancement
|
Hasan, Mohammed Flyyih
|
|
|
43 |
C |
p.
|
artikel
|
| 52 |
Thermal process simulation and multi-variable study/optimization of a novel geothermal-driven multi-generation process using bi-evaporator with zeotropic mixture
|
Zhan, Mingwang
|
|
|
43 |
C |
p.
|
artikel
|
| 53 |
Thermodynamics, environmental damage cost, exergoeconomic, life cycle, and exergoenvironmental analyses of a JP-8 fueled turbodiesel aviation engine at take-off phase
|
Korba, Peter
|
|
|
43 |
C |
p.
|
artikel
|
| 54 |
Thermohydraulic performance of DPHE affected by triangular and semi-circular cut size on insert: IoT-based experimentation
|
Diwaker, Manoj Kumar
|
|
|
43 |
C |
p.
|
artikel
|
| 55 |
Time-varying solar radiation-induced non-uniform temperature distribution of steel-concrete composite box girder-ballastless track system
|
Sheng, Xingwang
|
|
|
43 |
C |
p.
|
artikel
|
| 56 |
Triple diffusive Marangoni convection in a fluid-porous structure: Effects of a vertical magnetic field and temperature profiles
|
Yellamma,
|
|
|
43 |
C |
p.
|
artikel
|
Tijdschrift beschrijving