nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
A case study of a cogeneration system for a hospital in Greece. Economic and environmental impacts
|
Alexis, G.K. |
|
2013 |
54 |
2 |
p. 488-496 9 p. |
artikel |
2 |
A comparative evaluation of gray and non-gray radiation modeling strategies in oxy-coal combustion simulations
|
Nakod, Pravin |
|
2013 |
54 |
2 |
p. 422-432 11 p. |
artikel |
3 |
An experimental study of the cycle stability of hydraulic free-piston engines
|
Zhao, Zhenfeng |
|
2013 |
54 |
2 |
p. 365-371 7 p. |
artikel |
4 |
Design and study of an electrical liquid heater using conductive polymer composite tubes
|
Noel, Hervé |
|
2013 |
54 |
2 |
p. 507-515 9 p. |
artikel |
5 |
Dimethyl ether energy ratio effects in a dimethyl ether-diesel dual fuel premixed charge compression ignition engine
|
Wang, Ying |
|
2013 |
54 |
2 |
p. 481-487 7 p. |
artikel |
6 |
Editorial board
|
|
|
2013 |
54 |
2 |
p. IFC- 1 p. |
artikel |
7 |
Effects of ethanol–diesel–biodiesel blends on combustion and emissions in premixed low temperature combustion
|
Fang, Qiang |
|
2013 |
54 |
2 |
p. 541-548 8 p. |
artikel |
8 |
Experimental analysis of the effectiveness of a high temperature thermal storage tank for solar cooling applications
|
Gil, Antoni |
|
2013 |
54 |
2 |
p. 521-527 7 p. |
artikel |
9 |
Experimental and theoretical investigation of air-steam condensation in a vertical tube at low inlet steam fractions
|
Chantana, Chanamon |
|
2013 |
54 |
2 |
p. 399-412 14 p. |
artikel |
10 |
Experimental investigation of performance for the novel flat plate solar collector with micro-channel heat pipe array (MHPA-FPC)
|
Deng, Yuechao |
|
2013 |
54 |
2 |
p. 440-449 10 p. |
artikel |
11 |
Experimental performance evaluation for a carbon dioxide light commercial cooling application under transcritical and subcritical conditions
|
Boccardi, G. |
|
2013 |
54 |
2 |
p. 528-535 8 p. |
artikel |
12 |
Experimental validation of a coupled magneto-thermal model for a flat-parallel-plate active magnetic regenerator
|
Vuarnoz, D. |
|
2013 |
54 |
2 |
p. 433-439 7 p. |
artikel |
13 |
Heat protection by different phase change materials
|
Bühler, M. |
|
2013 |
54 |
2 |
p. 359-364 6 p. |
artikel |
14 |
Investigation of heat exchanger inclination in forced-draught air-cooled heat exchangers
|
Kennedy, Ian J. |
|
2013 |
54 |
2 |
p. 413-421 9 p. |
artikel |
15 |
Mitigation of crude oil fouling by turbulence enhancement in a batch stirred cell
|
Yang, Mengyan |
|
2013 |
54 |
2 |
p. 516-520 5 p. |
artikel |
16 |
Multi-nozzle spray cooling for high heat flux applications in a closed loop system
|
Tan, Y.B. |
|
2013 |
54 |
2 |
p. 372-379 8 p. |
artikel |
17 |
Numerical simulation of liquid film and regenerative cooling in a liquid rocket
|
Yang, Wei |
|
2013 |
54 |
2 |
p. 460-469 10 p. |
artikel |
18 |
Performance evaluation of Kalina cycle subsystem on geothermal power generation in the oilfield
|
Fu, Wencheng |
|
2013 |
54 |
2 |
p. 497-506 10 p. |
artikel |
19 |
Recuperator for waste heat recovery from rotary kilns
|
Karamarković, Vladan |
|
2013 |
54 |
2 |
p. 470-480 11 p. |
artikel |
20 |
Static study of traditional and ring networks and the use of mass flow control in district heating applications
|
Kuosa, Maunu |
|
2013 |
54 |
2 |
p. 450-459 10 p. |
artikel |
21 |
Study of the heat transfer and flow resistance of large and small hole (LASH) baffle heat exchanger
|
Sun, Haiyang |
|
2013 |
54 |
2 |
p. 536-540 5 p. |
artikel |
22 |
The experimental validation of a CFD model for a heating oven with natural air circulation
|
Smolka, Jacek |
|
2013 |
54 |
2 |
p. 387-398 12 p. |
artikel |
23 |
Thermal enhancement of PFA-based grout for geothermal heat exchangers
|
Alrtimi, A.A. |
|
2013 |
54 |
2 |
p. 559-564 6 p. |
artikel |
24 |
Thermal performance analysis of reciprocating compressor with stepless capacity control system
|
Bin, Tang |
|
2013 |
54 |
2 |
p. 380-386 7 p. |
artikel |
25 |
Three-dimensional conjugate heat transfer in partitioned enclosures: Determination of geometrical and thermal properties by an inverse method
|
Gossard, Didier |
|
2013 |
54 |
2 |
p. 549-558 10 p. |
artikel |