nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
A closed-loop electronics cooling by implementing single phase impinging jet and mini channels heat exchanger
|
Bintoro, Jemmy S. |
|
2005 |
25 |
17-18 |
p. 2740-2753 14 p. |
artikel |
2 |
Active desiccant integration with packaged rooftop HVAC equipment
|
Sand, James R. |
|
2005 |
25 |
17-18 |
p. 3138-3148 11 p. |
artikel |
3 |
Analysis of microchannel heat sink performance using nanofluids
|
Chein, Reiyu |
|
2005 |
25 |
17-18 |
p. 3104-3114 11 p. |
artikel |
4 |
Application of neural network for the modeling and control of evaporative condenser cooling load
|
Abbassi, A. |
|
2005 |
25 |
17-18 |
p. 3176-3186 11 p. |
artikel |
5 |
Assessment of the thermal performance and energy conservation opportunities of a cement industry in Indonesia
|
Rasul, M.G. |
|
2005 |
25 |
17-18 |
p. 2950-2965 16 p. |
artikel |
6 |
AUTHOR INDEX
|
|
|
2005 |
25 |
17-18 |
p. XVIII-XXV nvt p. |
artikel |
7 |
Computational model for refrigerators based on Peltier effect application
|
Astrain, D. |
|
2005 |
25 |
17-18 |
p. 3149-3162 14 p. |
artikel |
8 |
Constant flow rate charging characteristics of a full-scale stratified chilled water storage tank with double-ring slotted pipe diffusers
|
Bahnfleth, William P. |
|
2005 |
25 |
17-18 |
p. 3067-3082 16 p. |
artikel |
9 |
Cooling of oil injected screw compressors by oil atomisation
|
De Paepe, M. |
|
2005 |
25 |
17-18 |
p. 2764-2779 16 p. |
artikel |
10 |
Design of the measurements validation procedure and the expert system architecture for a cogeneration internal combustion engine
|
Barelli, L. |
|
2005 |
25 |
17-18 |
p. 2698-2714 17 p. |
artikel |
11 |
Effect of the trapped mass and its composition on the heat transfer in the compression cycle of a reciprocating engine
|
Armas, Octavio |
|
2005 |
25 |
17-18 |
p. 2842-2853 12 p. |
artikel |
12 |
Effects of geometric parameters on confined impinging jet heat transfer
|
Lou, Z.Q. |
|
2005 |
25 |
17-18 |
p. 2687-2697 11 p. |
artikel |
13 |
Environmental assessment of biogas co- or tri-generation units by life cycle analysis methodology
|
Chevalier, C. |
|
2005 |
25 |
17-18 |
p. 3025-3041 17 p. |
artikel |
14 |
Eulerian approach for multiphase flow simulation in a glass melter
|
Chang, S.L. |
|
2005 |
25 |
17-18 |
p. 3083-3103 21 p. |
artikel |
15 |
Evaluation of energy efficiency in biofuel drying by means of energy and exergy analyses
|
Holmberg, Henrik |
|
2005 |
25 |
17-18 |
p. 3115-3128 14 p. |
artikel |
16 |
Evaporation heat transfer and pressure drop characteristics of R-290 (propane), R-600 (butane), and a mixture of R-290/R-600 in the three-lines serpentine small-tube bank
|
Wen, Mao-Yu |
|
2005 |
25 |
17-18 |
p. 2921-2936 16 p. |
artikel |
17 |
Experimental investigation of a comfort heating system for a passenger vehicle with an air-cooled engine
|
Yigit, K. Suleyman |
|
2005 |
25 |
17-18 |
p. 2790-2799 10 p. |
artikel |
18 |
Experimental investigation of an adsorption desalination plant using low-temperature waste heat
|
Wang, Xiaolin |
|
2005 |
25 |
17-18 |
p. 2780-2789 10 p. |
artikel |
19 |
Flow characteristics in an annular burner with fully film cooling
|
Li, L. |
|
2005 |
25 |
17-18 |
p. 3013-3024 12 p. |
artikel |
20 |
Genetic algorithm based optimal chiller loading for energy conservation
|
Chang, Yung-Chung |
|
2005 |
25 |
17-18 |
p. 2800-2815 16 p. |
artikel |
21 |
Geometric optimization of thermoelectric coolers in a confined volume using genetic algorithms
|
Cheng, Yi-Hsiang |
|
2005 |
25 |
17-18 |
p. 2983-2997 15 p. |
artikel |
22 |
Impact of micro-CHP systems on domestic sector CO2 emissions
|
Peacock, A.D. |
|
2005 |
25 |
17-18 |
p. 2653-2676 24 p. |
artikel |
23 |
Influence of glass properties on the performance of double-glazed facades
|
Pérez-Grande, Isabel |
|
2005 |
25 |
17-18 |
p. 3163-3175 13 p. |
artikel |
24 |
Local shifts of the fluid composition in a simulated heat pump using R-407C
|
Youbi-Idrissi, M. |
|
2005 |
25 |
17-18 |
p. 2827-2841 15 p. |
artikel |
25 |
Modelling of a double-glass photovoltaic module using finite differences
|
Notton, G. |
|
2005 |
25 |
17-18 |
p. 2854-2877 24 p. |
artikel |
26 |
New correlation for natural convection of finned tube A-type air cooler
|
Farhadi, F. |
|
2005 |
25 |
17-18 |
p. 3053-3066 14 p. |
artikel |
27 |
Numerical study for the combustion characteristics of Orimulsion fuel in a small-scale combustor
|
Kim, Hey-Suk |
|
2005 |
25 |
17-18 |
p. 2998-3012 15 p. |
artikel |
28 |
Performance assessment of HCFC-22 window air conditioner retrofitted with R-407C
|
Devotta, S. |
|
2005 |
25 |
17-18 |
p. 2937-2949 13 p. |
artikel |
29 |
Reverse heat transfer and re-condensation phenomena in non-adiabatic capillary tubes
|
Bansal, P.K. |
|
2005 |
25 |
17-18 |
p. 3187-3202 16 p. |
artikel |
30 |
Simplified dynamic model for heat input and output of heat storing stoves
|
Saastamoinen, Jaakko |
|
2005 |
25 |
17-18 |
p. 2878-2890 13 p. |
artikel |
31 |
Simulation analysis for the active solar heating system of a passive house
|
Badescu, Viorel |
|
2005 |
25 |
17-18 |
p. 2754-2763 10 p. |
artikel |
32 |
Start-up from the frozen state of two-phase thermosyphons
|
Imura, Hideaki |
|
2005 |
25 |
17-18 |
p. 2730-2739 10 p. |
artikel |
33 |
Study of a gas–liquid ejector and its application to a solar-powered bi-ejector refrigeration system
|
Shen, Shengqiang |
|
2005 |
25 |
17-18 |
p. 2891-2902 12 p. |
artikel |
34 |
Study on a PCM heat storage system for rapid heat supply
|
Wei, Jinjia |
|
2005 |
25 |
17-18 |
p. 2903-2920 18 p. |
artikel |
35 |
The effect of ionisation of spray in cooling air on the wetting characteristics of finned tube heat exchanger
|
Esterhuyse, B.D. |
|
2005 |
25 |
17-18 |
p. 3129-3137 9 p. |
artikel |
36 |
The effects of injection timing on NO x emissions of a low heat rejection indirect diesel injection engine
|
Parlak, Adnan |
|
2005 |
25 |
17-18 |
p. 3042-3052 11 p. |
artikel |
37 |
Theoretical and experimental study of a direct contact thermal screw dryer for biomass residues
|
Al-Kassir, A. |
|
2005 |
25 |
17-18 |
p. 2816-2826 11 p. |
artikel |
38 |
Thermal performance analysis on a two composite material honeycomb heat regenerators used for HiTAC burners
|
Rafidi, Nabil |
|
2005 |
25 |
17-18 |
p. 2966-2982 17 p. |
artikel |
39 |
The use of infrared thermographic and GPS topographic surveys to monitor spontaneous combustion of coal tips
|
Carpentier, O. |
|
2005 |
25 |
17-18 |
p. 2677-2686 10 p. |
artikel |
40 |
VOLUME 22 CONTENTS
|
|
|
2005 |
25 |
17-18 |
p. III-XVII nvt p. |
artikel |
41 |
Water-to-water heat transfer in tube–tube heat exchanger: Experimental and analytical study
|
Rane, Milind V. |
|
2005 |
25 |
17-18 |
p. 2715-2729 15 p. |
artikel |