| nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
| 1 |
A comparative study between air cooling and liquid cooling thermal management systems for a high-energy lithium-ion battery module
|
Akbarzadeh, Mohsen
|
|
|
198 |
C |
p.
|
artikel
|
| 2 |
Advanced heat and mass recovery design in a two bed adsorption desalination system
|
Amirfakhraei, Amirhossein
|
|
|
198 |
C |
p.
|
artikel
|
| 3 |
Aerodynamic port-aligned fins to enhance thermal-hydraulic performance of jet impingement arrays
|
Elhagali, Ibrahim O.
|
|
|
198 |
C |
p.
|
artikel
|
| 4 |
Analysis of influence of different convex structures on cooling effect of rectangular water channel of motorized spindle
|
Tang, Yang
|
|
|
198 |
C |
p.
|
artikel
|
| 5 |
Analysis of lithium-ion battery thermal models inaccuracy caused by physical properties uncertainty
|
Dong, Ti
|
|
|
198 |
C |
p.
|
artikel
|
| 6 |
Analysis of operation and construction parameters for adsorption chiller performance with MATLAB/Simulink simulation
|
Gediz Ilis, Gamze
|
|
|
198 |
C |
p.
|
artikel
|
| 7 |
A new phase-change cooling method for the frequent start-stop electric motor
|
Liu, Xiangyang
|
|
|
198 |
C |
p.
|
artikel
|
| 8 |
A new structure optimization method for forced air-cooling system based on the simplified multi-physics model
|
Lyu, Chao
|
|
|
198 |
C |
p.
|
artikel
|
| 9 |
An experimental study on the heat transfer performance characteristics of horizontal tube falling film absorbers for single-stage absorption heat transformer
|
Jae Kim, Jeong
|
|
|
198 |
C |
p.
|
artikel
|
| 10 |
An experimental study on turbine vane Leading-Edge film cooling with deposition
|
Yang, Xing
|
|
|
198 |
C |
p.
|
artikel
|
| 11 |
A novel refrigerant-direct radiant cooling system: Numerical simulation-based evaluation
|
Jiang, Tingting
|
|
|
198 |
C |
p.
|
artikel
|
| 12 |
A novel solar assisted multigeneration system devoid of external utilities for drought adaptation considering water-exergy nexus analysis
|
Tariq, Shahzeb
|
|
|
198 |
C |
p.
|
artikel
|
| 13 |
A numerical model of a linear compressor for household refrigerator
|
Zhu, Zhennan
|
|
|
198 |
C |
p.
|
artikel
|
| 14 |
A semi-analytical model for evaluating the thermal storage capacity and heat use efficiency of flexible thermal storage heating floor
|
Guo, Jiwei
|
|
|
198 |
C |
p.
|
artikel
|
| 15 |
Assessment of a biomass-based polygeneration plant for combined power, heat, bioethanol and biogas
|
Lak Kamari, Mojtaba
|
|
|
198 |
C |
p.
|
artikel
|
| 16 |
Comparative analysis of battery electric vehicle thermal management systems under long-range drive cycles
|
Shelly, Tyler J.
|
|
|
198 |
C |
p.
|
artikel
|
| 17 |
Corrigendum to “Characterization of display pyrotechnic propellants: Colored light”. [Appl. Therm. Eng. 110 (2017) 1066–1074]
|
Ambekar, Anirudha
|
|
|
198 |
C |
p.
|
artikel
|
| 18 |
Desiccant cooling assisted vapor compression system: A double stage desiccant cooling cycle via evaporative condenser
|
Choi, Sung
|
|
|
198 |
C |
p.
|
artikel
|
| 19 |
Design, integration and performance analysis of a lid-integral microchannel cooling module for high-power chip
|
Chen, Chuan
|
|
|
198 |
C |
p.
|
artikel
|
| 20 |
Design of a novel LED bulb with entire surface thermally activated for passive cooling
|
Feng, Shangsheng
|
|
|
198 |
C |
p.
|
artikel
|
| 21 |
Design optimization of external variable displacement compressor with R1234yf for vehicle air conditioning system
|
Lee, Taejin
|
|
|
198 |
C |
p.
|
artikel
|
| 22 |
Editorial Board
|
|
|
|
198 |
C |
p.
|
artikel
|
| 23 |
Effect of the evaporator design parameters on the dynamic response of organic Rankine cycle units for waste heat recovery on heavy-duty vehicles
|
Carraro, Gianluca
|
|
|
198 |
C |
p.
|
artikel
|
| 24 |
Effects of air parameters on sewage sludge drying characteristics and regression analyses of drying model coefficients
|
Zheng, Qiushuang
|
|
|
198 |
C |
p.
|
artikel
|
| 25 |
Effects of port mixing and high carbon dioxide contents on power generation and emission characteristics of biogas-diesel RCCI combustion
|
Dalha, Ibrahim B.
|
|
|
198 |
C |
p.
|
artikel
|
| 26 |
Enhancement of the maximum heat transfer rate of the heat pipe through the bypass line
|
Jung, Eui Guk
|
|
|
198 |
C |
p.
|
artikel
|
| 27 |
Experimental investigation of solidification and melting in a vertically finned cavity
|
Abdi, Amir
|
|
|
198 |
C |
p.
|
artikel
|
| 28 |
Experimental investigations of flat T-shaped copper and titanium heat pipes
|
Nesterov, Denis A.
|
|
|
198 |
C |
p.
|
artikel
|
| 29 |
Experimental investigations of high-temperature shell and multi-tube latent heat storage system
|
Sodhi, Gurpreet Singh
|
|
|
198 |
C |
p.
|
artikel
|
| 30 |
Experimental study on the thermal performance of PCMs based heat sink using higher alcohol/graphite foam
|
Wang, Shisong
|
|
|
198 |
C |
p.
|
artikel
|
| 31 |
Fast nucleation of water by self-arrangement of hydrophilic crystals on a hierarchically structured surface promoting coalescence-induced droplet jumping
|
Han, Taeyang
|
|
|
198 |
C |
p.
|
artikel
|
| 32 |
Flow boiling of hydrocarbons and their zeotropic binary mixtures under pre- and post-dryout conditions
|
Oliveira, Guilherme H.S.
|
|
|
198 |
C |
p.
|
artikel
|
| 33 |
Flow thermohydraulic characterization of hierarchical-manifold microchannel heat sink with uniform flow distribution
|
Zhou, Jianhong
|
|
|
198 |
C |
p.
|
artikel
|
| 34 |
Heat transfer of a Stirling engine for waste heat recovery application from internal combustion engines
|
Catapano, Francesco
|
|
|
198 |
C |
p.
|
artikel
|
| 35 |
Impact of fin geometry and surface roughness on performance of an impingement two-phase cooling heat sink
|
Hoang, Cong Hiep
|
|
|
198 |
C |
p.
|
artikel
|
| 36 |
Improved design of heat sink including porous pin fins with different arrangements: A numerical turbulent flow and heat transfer study
|
Ranjbar, Ali Mohammad
|
|
|
198 |
C |
p.
|
artikel
|
| 37 |
Influence of Biot number and geometric parameters on the overall cooling effectiveness of double wall structure with pins
|
Liu, Xuebin
|
|
|
198 |
C |
p.
|
artikel
|
| 38 |
Investigation of boiling behaviors in vapor chambers in response to transient heat input profiles
|
Sudhakar, Srivathsan
|
|
|
198 |
C |
p.
|
artikel
|
| 39 |
Investigation on the combustion and performance characteristics of a DI free piston linear generator engine fuelled with CNG-CO2 blend
|
Ayandotun, Wasiu B.
|
|
|
198 |
C |
p.
|
artikel
|
| 40 |
Low Reynolds numbers convective heat transfer in single/two-phase roughened microchannels
|
Hsieh, Shou-Shing
|
|
|
198 |
C |
p.
|
artikel
|
| 41 |
Melting behavior of the latent heat thermal energy storage unit with fins and graded metal foam
|
Yang, Chao
|
|
|
198 |
C |
p.
|
artikel
|
| 42 |
Multi-objective optimization of a dual energy-driven solid oxide fuel cell-based power plant
|
Cao, Yan
|
|
|
198 |
C |
p.
|
artikel
|
| 43 |
Multi-physics modeling of thermochemical heat storage with enhance heat transfer
|
Shi, Tao
|
|
|
198 |
C |
p.
|
artikel
|
| 44 |
New steam turbine operational mode for a gas turbine combine cycle bottoming cycle system
|
Zhong, Zaixi
|
|
|
198 |
C |
p.
|
artikel
|
| 45 |
Numerical analysis on the thermal performance of microchannel heat sinks with Al2O3 nanofluid and various fins
|
Ali, Abdullah Masoud
|
|
|
198 |
C |
p.
|
artikel
|
| 46 |
Numerical investigation on heat transfer and thermoelastic stress in a solar cavity receiver
|
Fang, Jiabin
|
|
|
198 |
C |
p.
|
artikel
|
| 47 |
Numerical simulation of the thermal-hydraulic characteristics of supercritical carbon dioxide in a wire-wrapped rod bundle
|
Wang, Shunqi
|
|
|
198 |
C |
p.
|
artikel
|
| 48 |
Optimal control of fan coil battery air and water flow rates requiring minimal on-line measurements
|
Edwards, Kilian
|
|
|
198 |
C |
p.
|
artikel
|
| 49 |
Optimal structure design of supercritical CO2 power cycle for gas turbine waste heat recovery: A superstructure method
|
Yang, Chendi
|
|
|
198 |
C |
p.
|
artikel
|
| 50 |
Optimization of permeable membrane microchannel heat sinks for additive manufacturing
|
Ozguc, Serdar
|
|
|
198 |
C |
p.
|
artikel
|
| 51 |
Performance of circular Oscillating Heat Pipe for highly adaptable heat transfer layout
|
Okazaki, Shun
|
|
|
198 |
C |
p.
|
artikel
|
| 52 |
Performance of energy storage system containing cement mortar and PCM/epoxy/SiC composite fine aggregate
|
Yoo, Dong Ho
|
|
|
198 |
C |
p.
|
artikel
|
| 53 |
Performance optimization for a combustion-based micro thermoelectric generator with two-stage thermoelectric module
|
Zhao, Zhengyang
|
|
|
198 |
C |
p.
|
artikel
|
| 54 |
Techno-economic analysis of multi-generation liquid air energy storage system
|
Cui, Shuangshuang
|
|
|
198 |
C |
p.
|
artikel
|
| 55 |
Temperature oscillation of a dual compensation chamber loop heat pipe under acceleration conditions
|
Lv, Xiaochen
|
|
|
198 |
C |
p.
|
artikel
|
| 56 |
Thermal energy storage using phase change material: Analysis of partial tank charging and discharging on system performance in a building cooling application
|
McKenna, P.
|
|
|
198 |
C |
p.
|
artikel
|
| 57 |
Thermal modeling and designing of microchannel condenser for refrigeration applications operating with isobutane (R600a)
|
Başaran, Anıl
|
|
|
198 |
C |
p.
|
artikel
|
| 58 |
Thermodynamic analysis of an ammonia-water solution cross-type absorption-resorption heat pump system
|
Feng, Lijie
|
|
|
198 |
C |
p.
|
artikel
|
| 59 |
Waste heat recovery of a combined solid oxide fuel cell - gas turbine system for multi-generation purposes
|
Cao, Yan
|
|
|
198 |
C |
p.
|
artikel
|
Tijdschrift beschrijving