Digital Library
Close Browse articles from a journal
     Journal description
       All volumes of the corresponding journal
         All issues of the corresponding volume
                                       All articles of the corresponding issues
 
                             77 results found
no title author magazine year volume issue page(s) type
1 Adaptive attitude angle constrained fault-tolerant control of hypersonic vehicle with unknown centroid shift Meng, Yizhen

140 C p.
article
2 A directly coil-actuated cyclic pitch control based rotor: Design, modeling, and analysis Wu, Qi

140 C p.
article
3 Adjoint-based robust optimization design of laminar flow airfoil under flight condition uncertainties Chen, Yifu

140 C p.
article
4 Aerodynamic performance measurement of a novel variable geometry turbine adjustable guide vane scheme by experimental study Yao, Yunjia

140 C p.
article
5 Aerothermal characteristics of thin double-wall effusion cooling systems with novel slot holes and cellular architectures for gas turbines Gu, Huaduo

140 C p.
article
6 A methodology for estimating hypersonic engine performance by coupling supersonic reactive flow simulations with machine learning techniques Ispir, Ali Can

140 C p.
article
7 A novel training point selection strategy guided by the maximum reduction of structural state misclassification probability for time-dependent reliability analysis Lu, Yixin

140 C p.
article
8 A posture alignment-based methodology for gap optimization of aircraft composite panel assembly Sun, Zhichao

140 C p.
article
9 Applicability analysis of inverse method of characteristics Liu, Chuanzhen

140 C p.
article
10 Boundary layer suction timing and location effects on unstarting flows in a model scramjet Hwang, Jeongjae

140 C p.
article
11 Characteristics of flame acceleration and deflagration-to-detonation transition enhanced by SF6 jet-in-cross-flow/flame interaction Cheng, Jun

140 C p.
article
12 Chebyshev-series solutions for nonlinear systems with hypersonic gliding trajectory example Yang, Jin

140 C p.
article
13 Continuous monitoring scheduling for moving targets by Earth observation satellites Han, Xiaofeng

140 C p.
article
14 Corrigendum to “Supercritical wing design based on airfoil optimization and 2.75D transformation” [Aerosp. Sci. Technol. 56 (2016) 168–182] Zhao, Tong

140 C p.
article
15 Differential geometric guidance law design for varying-speed missile Liu, Yuanhe

140 C p.
article
16 Editorial Board
140 C p.
article
17 Effects of structured prefilmer lip on spray characteristics in planar prefilming airblast atomization An, Xiang

140 C p.
article
18 Evaluation of the free-windmilling rotational speed of a damaged wide-chord fan rotor Zhang, Jiguo

140 C p.
article
19 Event-triggered nonlinear information fusion preview control of a two-degree-of-freedom helicopter system Xu, Qingzheng

140 C p.
article
20 Experimental investigation of flow unsteadiness over four types of spiked-blunt body at Mach 2.2 Guan, Ruiqing

140 C p.
article
21 Experimental investigation on evaporation characteristics of RP-3 aviation kerosene droplet above the critical temperature under various pressure conditions Yin, Jing

140 C p.
article
22 Experimental investigation on supersonic film cooling of hypersonic optical dome under different nozzle pressure ratios Sun, Xiaobin

140 C p.
article
23 Experimental research of the performance and pressure gain in continuous detonation engines with aerospike nozzles Ma, John Z.

140 C p.
article
24 Fast performance prediction and field reconstruction of gas turbine using supervised graph learning approaches Li, Jinxing

140 C p.
article
25 Finite-time anti-disturbance control of an information-constrained autonomous helicopter flexible slung-load system with compound disturbance Ren, Yong

140 C p.
article
26 Fixed-time sliding mode control for hypersonic morphing vehicles via event-triggering mechanism Zhang, Hao

140 C p.
article
27 Flutter analysis of multi-directional functionally graded sector poroelastic disks Tang, Jianjiang

140 C p.
article
28 Fuel sloshing-induced effects on the dynamic response of a scaled research wing demonstrator Constantin, Lucian

140 C p.
article
29 Fuzzy logic-based adaptive tracking weight-tuned direct performance predictive control method of aero-engine Chen, Qian

140 C p.
article
30 Hybrid iteration and optimization-based three-dimensional reconstruction for space non-cooperative targets with monocular vision and sparse lidar fusion Zhang, Chi

140 C p.
article
31 Impact at aircraft level of elastic efficiency of a forward-swept tailplane Corcione, Salvatore

140 C p.
article
32 Improved hybrid model for transitional separated flows over a rough compressor blade Qiao, Lei

140 C p.
article
33 Influence of air swirl orientation on the spray characteristics of a micro-channel-based rotary (MCR) atomizer Kumar, Anjith

140 C p.
article
34 Instabilities identification based on a new centrifugal 3D impeller outflow model Fan, Meng

140 C p.
article
35 Investigation of the controlling mechanisms of blade slotting technology on the shock-wave-induced corner separation Wang, Hejian

140 C p.
article
36 Investigation of the influence mechanism of geometric throats in variable-geometry rocket-based combined-cycle combustors Ye, Jinying

140 C p.
article
37 Least global position information based control of fixed-wing UAVs formation flight: Flight tests and experimental validation Wang, Rui

140 C p.
article
38 Mechanisms of low frequency pressure oscillation occurred in oxygen jet condensation based on height function method Zhu, Chengfeng

140 C p.
article
39 Modelling, control and simulation of a single rotor UAV with swashplateless torque modulation Bernardes, Evandro

140 C p.
article
40 Non-axisymmetric design and flow field analysis of boundary layer ingesting fans Yu, Junyang

140 C p.
article
41 Nonlinear low-velocity impact of graphene platelets reinforced metal foams cylindrical shell: Effect of spinning motion and initial geometric imperfections Ding, Hao-Xuan

140 C p.
article
42 Normalized nodal distance-based J 2-perturbed ground-track adjustment with apsidal-altitude constraints Sheng, Jing

140 C p.
article
43 Numerical and experimental analysis of fuel regression rate in a lab-scale hybrid rocket engine with swirl injection Migliorino, Mario Tindaro

140 C p.
article
44 Numerical investigation of the effect of CMAS deposition on the temperature and stress distribution of thermal barrier coatings coated on a turbine blade Liu, X.H.

140 C p.
article
45 Observer based incremental backstepping terminal sliding-mode control with learning rate for a multi-vectored propeller airship Liu, Shi Qian

140 C p.
article
46 On the effectiveness of double-double design on crashworthiness of fuselage barrel Garofano, Antonio

140 C p.
article
47 Operational instability of a high-rotational-speed electric pump in a hybrid rocket motor Gu, Xiaoming

140 C p.
article
48 Optimization and parametric studies of two-stage-to-orbit liquid oxygen/paraffin hybrid rocket vehicles Messinger, Troy L.

140 C p.
article
49 Origami-inspired isolators with quasi-zero stiffness for coupled axial-torsional vibration Han, Hesheng

140 C p.
article
50 Predefined-time fault-tolerant attitude control for tailless aircraft considering actuator input saturation Yu, Zhilong

140 C p.
article
51 Prescribed finite-time boundary control of constrained flexible satellite systems with translational motion modeling Zhang, Xing-Yu

140 C p.
article
52 Prescribed-time constrained feedback control for an uncertain twin rotor helicopter Singh, Vijay Kumar

140 C p.
article
53 Pretension design for mesh reflector antennas with flexible trusses and hinges based on the equilibrium matrix method Yuan, Pengfei

140 C p.
article
54 Primary and subharmonic resonance features of a graphene nanoplatelet strengthened beam in a thermal ambient directly attacking nonlinear integro-partial differential governing equations Luo, Jijun

140 C p.
article
55 Quantitative analysis of enhanced mixing and combustion by lobed mixer in a ramjet engine: Study using hyperbolic Lagrangian coherent structures Sun, Lin

140 C p.
article
56 Rapid cooperative optimization of continuous trajectory for electric sails in multiple formation reconstruction scenarios Jin, Ruhao

140 C p.
article
57 Real-time online unstart prediction of supersonic inlet based on pressure fluctuations Wang, Yu-Jie

140 C p.
article
58 Recursive identification of the time-varying frequency parameters of a space solar power satellite using a robust subspace tracking method based on the variable forgetting factor Ni, Zhiyu

140 C p.
article
59 Research on time series prediction of the flow field in supersonic combustor based on deep learning Guo, Mingming

140 C p.
article
60 Robust guidance law for cooperative aerial target circumnavigation of UAVs based on composite system theory Zhang, Min

140 C p.
article
61 Scramjet combustion with bumpy struts Zhang, Lan

140 C p.
article
62 Shadow removal of spacecraft images with multi-illumination angles image fusion Xiang, Ao

140 C p.
article
63 Simulation of aircraft multi-axis acceleration in a four-axis Human Centrifuge System Winter, Asher

140 C p.
article
64 State-space dynamic inflow modelling for hovering rotors in fixed- and moving-ground effect Pasquali, Claudio

140 C p.
article
65 Structural and aeroelastic characteristics of wing model for transonic flutter wind tunnel test fabricated by additive manufacturing with AlSi10Mg alloys Tsushima, Natsuki

140 C p.
article
66 Study of a non-reacting hypersonic flow over an external cavity with flow injection using DSMC method Lekzian, E.

140 C p.
article
67 μ-Synthesis-based robust L 1 adaptive control for aeropropulsion system test facility Liu, Jiashuai

140 C p.
article
68 Test mass 6-DOF control allocation based on the null space for space gravitational wave mission Zhang, Jinxiu

140 C p.
article
69 The determination of physical dimensions of a hypersonic three-stage compression system considering panel vibration effects Gou, Jian-Jun

140 C p.
article
70 The source localization and dynamical evolution of axisymmetric screech modes in underexpanded supersonic jets Li, Hu

140 C p.
article
71 Three-dimensional impact-time-constrained proportional navigation guidance using range-varying gain Kang, Honglong

140 C p.
article
72 Time-varying stability and vibration of an embedded thin plate on a swept wing Yao, Guo

140 C p.
article
73 Trajectory optimization for takeoff and landing phase of UAM considering energy and safety Park, Jin

140 C p.
article
74 Transonic buffet alleviation via virtual control surfaces Petrocchi, Andrea

140 C p.
article
75 Validation of numerical simulations for investigating flow control in hypersonic inlets Park, Yoonsik

140 C p.
article
76 Wall temperature effects on wall heat flux in high-enthalpy turbulent boundary layers Liu, PengXin

140 C p.
article
77 Wing geometry and kinematic parameters optimization of bat-like robot fixed-altitude flight for minimum energy Duan, Bosong

140 C p.
article
                             77 results found
 
 Koninklijke Bibliotheek - National Library of the Netherlands