| no |
title |
author |
magazine |
year |
volume |
issue |
page(s) |
type |
| 1 |
Archeometallurgy related to swords
|
Wadsworth, Jeffrey
|
|
2015
|
99 |
C |
p. 1-7
|
article
|
| 2 |
Bending properties and fracture behaviors of ZnO coated aluminum borate whiskers reinforced 2024Al composites
|
Yue, H.Y.
|
|
2015
|
99 |
C |
p. 47-51
|
article
|
| 3 |
Controlling the sol–gel process of nano-crystalline lithium-mica glass-ceramic by its chemical composition and synthesis parameters
|
Tohidifar, M.R.
|
|
2015
|
99 |
C |
p. 61-67
|
article
|
| 4 |
Corrigendum to “High-temperature low cycle fatigue behavior of a gray cast iron” [Mater. Charact. (2014) 37–46]
|
Fan, K.L.
|
|
2015
|
99 |
C |
p. 287
|
article
|
| 5 |
Delamination of near-surface layer on cold rolled AlFeSi alloy during sheet forming
|
Wang, J.
|
|
2015
|
99 |
C |
p. 109-117
|
article
|
| 6 |
Development of nano-structured duplex and ferritic stainless steels by pulverisette planetary milling followed by pressureless sintering
|
R, Shashanka.
|
|
2015
|
99 |
C |
p. 220-229
|
article
|
| 7 |
Editorial Advisory Board
|
|
|
2015
|
99 |
C |
p. ii
|
article
|
| 8 |
Effect of wheel speed on the microstructure and nanohardness of rapidly solidified Ti–48Al–2Cr alloy
|
Zhu, Dongdong
|
|
2015
|
99 |
C |
p. 243-247
|
article
|
| 9 |
Effects of W on microstructure of as-cast 28wt.%Cr–2.6wt.%C–(0–10)wt.%W irons
|
Imurai, S.
|
|
2015
|
99 |
C |
p. 52-60
|
article
|
| 10 |
Elevated temperature tensile properties and deformation of directionally solidified NiAl–Mo in-situ composites
|
Zhang, Jian-Fei
|
|
2015
|
99 |
C |
p. 160-165
|
article
|
| 11 |
Fe-doped nanostructured titanates synthesized in a single step route
|
Costa, A.M.L.M.
|
|
2015
|
99 |
C |
p. 150-159
|
article
|
| 12 |
Fine precipitation scenarios of AlZnMg(Cu) alloys revealed by advanced atomic-resolution electron microscopy study Part II: Fine precipitation scenarios in AlZnMg(Cu) alloys
|
Liu, J.Z.
|
|
2015
|
99 |
C |
p. 142-149
|
article
|
| 13 |
Fine precipitation scenarios of AlZnMg(Cu) alloys revealed by advanced atomic-resolution electron microscopy study Part I: Structure determination of the precipitates in AlZnMg(Cu) alloys
|
Liu, J.Z.
|
|
2015
|
99 |
C |
p. 277-286
|
article
|
| 14 |
Formation of ZrO2 in coating on Mg–3wt.%Al–1wt.%Zn alloy via plasma electrolytic oxidation: Phase and structure of zirconia
|
Lee, Kang Min
|
|
2015
|
99 |
C |
p. 101-108
|
article
|
| 15 |
General study on the crystal, electronic and band structures, the morphological characterization, and the magnetic properties of the Sr2DyRuO6 complex perovskite
|
Triana, C.A.
|
|
2015
|
99 |
C |
p. 128-141
|
article
|
| 16 |
Grain size effect on electrical resistivity of bulk nanograined Bi2Te3 material
|
Ivanov, Oleg
|
|
2015
|
99 |
C |
p. 175-179
|
article
|
| 17 |
Immediate impact on the rim zone of cement based materials due to chemical attack
|
Schwotzer, M.
|
|
2015
|
99 |
C |
p. 77-83
|
article
|
| 18 |
In-situ TEM/heavy ion irradiation on ultrafine-and nanocrystalline-grained tungsten: Effect of 3MeV Si, Cu and W ions
|
El-Atwani, O.
|
|
2015
|
99 |
C |
p. 68-76
|
article
|
| 19 |
Interfacial microstructure of copper/diamond composites fabricated via a powder metallurgical route
|
Grzonka, Justyna
|
|
2015
|
99 |
C |
p. 188-194
|
article
|
| 20 |
Investigation of deformation micro-mechanisms in nickel consolidated from a bimodal powder by spark plasma sintering
|
Tingaud, D.
|
|
2015
|
99 |
C |
p. 118-127
|
article
|
| 21 |
Low temperature one-step synthesis of rutile TiO2/BiOCl composites with enhanced photocatalytic activity
|
Duo, Fangfang
|
|
2015
|
99 |
C |
p. 8-16
|
article
|
| 22 |
Magnesia tuned multi-walled carbon nanotubes–reinforced alumina nanocomposites
|
Ahmad, Iftikhar
|
|
2015
|
99 |
C |
p. 210-219
|
article
|
| 23 |
Microstructural evolution and the variation of tensile behavior after aging heat treatment of precipitation hardened martensitic steel
|
Shin, Jong-Ho
|
|
2015
|
99 |
C |
p. 230-237
|
article
|
| 24 |
Microstructure and properties of the Ti(C,N)–xMo2C–Ni cermet/steel joint by a novel diffusion bonding method
|
Guo, Zhixing
|
|
2015
|
99 |
C |
p. 92-100
|
article
|
| 25 |
On the measurement of austenite in supermartensitic stainless steel by X-ray diffraction
|
Tolchard, Julian Richard
|
|
2015
|
99 |
C |
p. 238-242
|
article
|
| 26 |
Oxidation and alpha-case formation in Ti–6Al–2Sn–4Zr–2Mo alloy
|
Gaddam, Raghuveer
|
|
2015
|
99 |
C |
p. 166-174
|
article
|
| 27 |
Refining and nucleating behaviors of AlP on primary phase in Al–Ge and Al–Ge–Si alloys
|
Zhang, Yongrui
|
|
2015
|
99 |
C |
p. 195-199
|
article
|
| 28 |
Researching a highly anti-corrosion superhydrophobic film fabricated on AZ91D magnesium alloy and its anti-bacteria adhesion effect
|
Wang, Zhongwei
|
|
2015
|
99 |
C |
p. 200-209
|
article
|
| 29 |
Segmentation, statistical analysis, and modelling of the wall system in ceramic foams
|
Kampf, Jürgen
|
|
2015
|
99 |
C |
p. 38-46
|
article
|
| 30 |
Semiconductor-to-metallic flipping in a ZnFe2O4–graphene based smart nano-system: Temperature/microwave magneto-dielectric spectroscopy
|
Ameer, Shahid
|
|
2015
|
99 |
C |
p. 254-265
|
article
|
| 31 |
Studies on densification, mechanical, micro-structural and structure–properties relationship of magnesium aluminate spinel refractory aggregates prepared from Indian magnesite
|
Ghosh, Chandrima
|
|
2015
|
99 |
C |
p. 84-91
|
article
|
| 32 |
Tapioca starch: An efficient fuel in gel-combustion synthesis of photocatalytically and anti-microbially active ZnO nanoparticles
|
Ramasami, Alamelu K.
|
|
2015
|
99 |
C |
p. 266-276
|
article
|
| 33 |
Tensile and compressive creep behavior of extruded Mg–10Gd–3Y–0.5Zr (wt.%) alloy
|
Wang, H.
|
|
2015
|
99 |
C |
p. 25-37
|
article
|
| 34 |
The effect of postprocessing on tensile property and microstructure evolution of friction stir welding aluminum alloy joint
|
Hu, Z.L.
|
|
2015
|
99 |
C |
p. 180-187
|
article
|
| 35 |
The influence of Zr content on microstructure and precipitation of silicide in as-cast near α titanium alloys
|
Fu, Binguo
|
|
2015
|
99 |
C |
p. 17-24
|
article
|
| 36 |
The relationships between residual stress relaxation and texture development in AZ31 Mg alloys via the vibratory stress relief technique
|
Wang, Jia-Siang
|
|
2015
|
99 |
C |
p. 248-253
|
article
|
Journal description