no |
title |
author |
magazine |
year |
volume |
issue |
page(s) |
type |
1 |
A method to correct coordinate distortion in EBSD maps
|
Zhang, Y.B. |
|
2014 |
96 |
C |
p. 158-165 8 p. |
article |
2 |
Anion-controlled synthesis of TiO2 nano-aggregates for Li ion battery electrodes
|
Song, Hee Jo |
|
2014 |
96 |
C |
p. 13-20 8 p. |
article |
3 |
Calculation of contact angles at triple phase boundary in solid oxide fuel cell anode using the level set method
|
Sun, Xiaojun |
|
2014 |
96 |
C |
p. 100-107 8 p. |
article |
4 |
Comparative dielectric studies of nanostructured BaTiO3, CaCu3Ti4O12 and 0.5BaTiO3⋅0.5CaCu3Ti4O12 nano-composites synthesized by modified sol–gel and solid state methods
|
Singh, Laxman |
|
2014 |
96 |
C |
p. 54-62 9 p. |
article |
5 |
Development and characterisations of WC–12Co microwave clad
|
Zafar, Sunny |
|
2014 |
96 |
C |
p. 241-248 8 p. |
article |
6 |
Dual-phase glassy/nanoscale icosahedral phase materials in Cu–Zr–Ti–Pd system alloys
|
Louzguine-Luzgin, Dmitri V. |
|
2014 |
96 |
C |
p. 6-12 7 p. |
article |
7 |
Editorial Board
|
|
|
2014 |
96 |
C |
p. ii- 1 p. |
article |
8 |
Effect of cold drawing ratio on γ′ precipitation in Inconel X-750
|
Ha, Jeong Won |
|
2014 |
96 |
C |
p. 1-5 5 p. |
article |
9 |
Effects of d.c. current on the phase transformation in 7050 alloy during homogenization
|
Jia, P.F. |
|
2014 |
96 |
C |
p. 21-27 7 p. |
article |
10 |
Effects of interstitial Li+ ions on the properties of novel Li4.08Zn0.04Si0.96O4 ceramic electrolyte
|
Adnan, S.B.R.S. |
|
2014 |
96 |
C |
p. 249-255 7 p. |
article |
11 |
Effects of porosity on corrosion resistance of Mg alloy foam produced by powder metallurgy technology
|
Aghion, E. |
|
2014 |
96 |
C |
p. 78-83 6 p. |
article |
12 |
Effects of Sn addition on the microstructure, mechanical properties and corrosion behavior of Ti–Nb–Sn alloys
|
Moraes, Paulo E.L. |
|
2014 |
96 |
C |
p. 273-281 9 p. |
article |
13 |
Effects of V addition on recrystallization resistance of 7150 aluminum alloy after simulative hot deformation
|
Lai, Jing |
|
2014 |
96 |
C |
p. 126-134 9 p. |
article |
14 |
Electron backscatter diffraction study of deformation and recrystallization textures of individual phases in a cross-rolled duplex steel
|
Zaid, Md |
|
2014 |
96 |
C |
p. 263-272 10 p. |
article |
15 |
Experimental and theoretical investigation on the compressive behavior of aluminum borate whisker reinforced 2024Al composites
|
Yang, Cheng |
|
2014 |
96 |
C |
p. 84-92 9 p. |
article |
16 |
Fabrication and characterization of copper oxide (CuO)–gold (Au)–titania (TiO2) and copper oxide (CuO)–gold (Au)–indium tin oxide (ITO) nanowire heterostructures
|
Chopra, Nitin |
|
2014 |
96 |
C |
p. 71-77 7 p. |
article |
17 |
Friction stir welding of as-extruded Mg–Al–Zn alloy with higher Al content. Part I: Formation of banded and line structures
|
Yang, J. |
|
2014 |
96 |
C |
p. 142-150 9 p. |
article |
18 |
Friction stir welding of as-extruded Mg–Al–Zn alloy with higher Al content. Part II: Influence of precipitates
|
Yang, J. |
|
2014 |
96 |
C |
p. 135-141 7 p. |
article |
19 |
Hardness characteristic and shear band formation in metastable β-titanium alloys
|
Manda, Premkumar |
|
2014 |
96 |
C |
p. 151-157 7 p. |
article |
20 |
Hot deformation and processing maps of a Fe–Al intermetallic alloy
|
Łyszkowski, Radosław |
|
2014 |
96 |
C |
p. 196-205 10 p. |
article |
21 |
M23C6 precipitation behavior and grain boundary serration in Ni-based Alloy 690
|
Lim, Yun Soo |
|
2014 |
96 |
C |
p. 28-39 12 p. |
article |
22 |
Mechanical Characterisation of the Effect of Various Forming Processes Applied to Commercially Pure Titanium
|
Els-Botes, A. |
|
2014 |
96 |
C |
p. 206-212 7 p. |
article |
23 |
Microstructural characterization of weld joints of 9Cr reduced activation ferritic martensitic steel fabricated by different joining methods
|
Thomas Paul, V. |
|
2014 |
96 |
C |
p. 213-224 12 p. |
article |
24 |
Small-angle neutron scattering analysis of Mn–C clusters in high-manganese 18Mn–0.6C steel
|
Kang, Mihyun |
|
2014 |
96 |
C |
p. 40-45 6 p. |
article |
25 |
Structural, negative thermal expansion and photocatalytic properties of ZrV2O7: a comparative study between fibers and powders
|
Liu, Qinqin |
|
2014 |
96 |
C |
p. 63-70 8 p. |
article |
26 |
Structural properties of pure and Fe-doped Yb films prepared by vapor condensation
|
Rojas-Ayala, C. |
|
2014 |
96 |
C |
p. 108-114 7 p. |
article |
27 |
Structures in textured Cu–Al–Ni shape memory thin films grown by sputtering
|
Espinoza Torres, C. |
|
2014 |
96 |
C |
p. 256-262 7 p. |
article |
28 |
Study of the microstructure of plasma sprayed coatings obtained from Al2O3–13TiO2 nanostructured and conventional powders
|
Góral, A. |
|
2014 |
96 |
C |
p. 234-240 7 p. |
article |
29 |
Synthesis and Characterization of Urchin-like Mischcrystal TiO2 and Its Photocatalysis
|
Zuo, Shixiang |
|
2014 |
96 |
C |
p. 177-182 6 p. |
article |
30 |
Synthesis and structural evaluation of freeze-cast porous alumina
|
Souza, Douglas F. |
|
2014 |
96 |
C |
p. 183-195 13 p. |
article |
31 |
The effect of a notch on the Portevin–Le Chatelier phenomena in an Al–3Mg model alloy
|
Maj, P. |
|
2014 |
96 |
C |
p. 46-53 8 p. |
article |
32 |
The effect of boron addition on microstructure and mechanical properties of biomedical Ti35Nb6Ta alloy
|
Málek, Jaroslav |
|
2014 |
96 |
C |
p. 166-176 11 p. |
article |
33 |
The interrelationship of fracture toughness and microstructure in a new near β titanium alloy Ti–7Mo–3Nb–3Cr–3Al
|
Fan, J.K. |
|
2014 |
96 |
C |
p. 93-99 7 p. |
article |
34 |
The metal alloys from the XIX century and weathering action in the Mercado do Ver-o-Peso building, northern Brazil: Identification with the usage of laboratory analysis
|
Palácios, Flávia Olegário |
|
2014 |
96 |
C |
p. 225-233 9 p. |
article |
35 |
The use of a directional solidification technique to investigate the interrelationship of thermal parameters, microstructure and microhardness of Bi–Ag solder alloys
|
Spinelli, José Eduardo |
|
2014 |
96 |
C |
p. 115-125 11 p. |
article |