Digital Library
Close Browse articles from a journal
     Journal description
       All volumes of the corresponding journal
         All issues of the corresponding volume
                                       All articles of the corresponding issues
 
                             59 results found
no title author magazine year volume issue page(s) type
1 Accurately evaluate anti-magnetic field interference ability: A study on magnetic field interference degree analysis method for magnetic sensors Li, Shenwang

372 C p.
article
2 AC poling-induced giant piezoelectricity and high mechanical quality factor in [001] PMN-PZT hard single crystals Kumar, Ajeet

372 C p.
article
3 A hypersensitive pressure sensor array for phase change microfluidics analysis Biancone, Chris J.

372 C p.
article
4 A lift-off measurement and compensation method based on a comprehensive EMAT-PEC probe Duan, Zhaoqi

372 C p.
article
5 A review on graphene-based sensors for tactile applications He, Shan

372 C p.
article
6 A review on soft pneumatic actuators with integrated or embedded soft sensors Gariya, Narendra

372 C p.
article
7 A silicone rubber packaged distributed optical fiber sensing tape for strain-crack monitoring based on OFDR technique Zhao, Lizhi

372 C p.
article
8 A tri-modal dielectric elastomer actuator integrating linear actuation, sound generation, and self-sensing capabilities Gratz-Kelly, Sebastian

372 C p.
article
9 Cold and ultra-cold chain integrity monitoring via embedded resonant sensor indicators Chan, Yee Jher

372 C p.
article
10 Contrastive domain generalization convolution neural network correcting the drift of gas sensors Chu, Jifeng

372 C p.
article
11 Corrigendum to “Bioinspired multi-asymmetric magnetized surfaces for tailored liquid operations and 3-DOF solid transport” [Sens. Actuators A: Phys. 368 (2024) 115104] Miao, Jiaqi

372 C p.
article
12 2D Analysis and simulation of quartz crystal etch penetration by revisiting a previous geometric method Zhao, Xinjia

372 C p.
article
13 Data assimilation to determine the electrohydrodynamic force of plasma actuator Kaneko, Yutaka

372 C p.
article
14 Development of a high sensitivity hydrophone at a spectrum range from 0.1 Hz to 100 kHz Motsi, Nefeli

372 C p.
article
15 Editorial Board
372 C p.
article
16 Effect of overheat and direct flow loading on the MEMS bistable flow sensor Litvinov, Ivan

372 C p.
article
17 Electrochemical approach for nonenzymatic glucose sensing with noble metal-free 2D graphene-based ternary nanocomposite Kabir, Latiful

372 C p.
article
18 Enhanced high-frequency piezoelectric ultrasonic transducer based on integrated AlN honeycomb structure Duan, Xiaoya

372 C p.
article
19 Flexible multi-electrode neural probe using active-matrix design of transistor array Chae, Jiwon

372 C p.
article
20 Flexible wearable ionogels: Classification, fabrication, properties and applications Zhang, Ying-Ao

372 C p.
article
21 Green synthesized SiO2/Bi2O3 nanocomposite sensor for catechol and hydroquinone detection in water Hasan, Ibrahem M.A.

372 C p.
article
22 Highly-accurate and non-invasive flowrate monitoring for miniature pipelines using piezoelectric micromachined ultrasonic transducers Li, Zixuan

372 C p.
article
23 Highly affordable electrothermal actuators based on an embedded Cu microheater with a high-resolution pattern Nguyen, Duc Cuong

372 C p.
article
24 High-performance ethanol sensor based on self-assembled BaTiO3/ZnO composite hierarchical nanostructure Xu, Xiaoli

372 C p.
article
25 High-performance flexible piezoelectric sensors based on honeycomb graphene macro-film exploiting auxetic mechanical property Zheng, Haoyu

372 C p.
article
26 Impact of alternating precursor supply and gas flow on the LPCVD growth behavior of polycrystalline 3C-SiC thin films on Si Moll, Philipp

372 C p.
article
27 Improvement in performance of SnSe-based photodetectors via post deposition sulfur diffusion Yılmaz, Salih

372 C p.
article
28 Integrated design and manufacturing of a soft robotic glove with piezoresistive sensors Chen, Chin-Tai

372 C p.
article
29 Interferometric characterization of high-frequency piezoelectric effects in hydroxyapatite thin films Islas-García, E.

372 C p.
article
30 Investigating the annealing effects on the performance of polyvinyl alcohol-graphite-based triboelectric nanogenerator Amini, Sebghatullah

372 C p.
article
31 KNN lead-free technology on 200 mm Si wafer for piezoelectric actuator applications Kuentz, Hugo

372 C p.
article
32 Lab-on-PCB technology for liquid monopropellant microthrusters: Design, fabrication, and performance evaluation Lee, Jeongrak

372 C p.
article
33 Low-frequency noise suppression method based on rotational modulation for vectorized magnetic sensor Guo, Jianmei

372 C p.
article
34 Magnetic trap-based steering method for small-scale robots: Feasibility study Kim, Jayoung

372 C p.
article
35 Manufacturing of bioinspired Bouligand structures using ultrasound assisted 3D printing Zheng, Tengfei

372 C p.
article
36 Microwave sensors loaded with metamaterial-inspired resonators for dielectric material characterization: A review Sim, Man Seng

372 C p.
article
37 Modeling and testing of a highly sensitive surface acoustic wave pressure sensor for liquid depth measurements Sreejith, Vattaparambil Sreedharan

372 C p.
article
38 Modified Pb(Mg1/3Nb2/3)O3-PbZrO3-PbTiO3 ceramics with high d 33,large Q m and high T c Wang, Chao

372 C p.
article
39 Monolithic MWCNT-hyperelastic elastomer based electronic skin with ultra-high stretchability for human health monitoring Pandey, Deepak

372 C p.
article
40 Multi-objective design optimization of electromagnetic coil for effective actuation of magnetic endocapsule devices Nallabothula, Brahmaiah

372 C p.
article
41 Nanowire sensor calibration and performance evaluation in microfluidic flow velocity monitoring Dong, Zhe

372 C p.
article
42 Planar non-contact microwave sensor for the detection of aqueous organic and inorganic samples El Yassini, Abdessalam

372 C p.
article
43 Preparation of PVA/CNTs film with high stability and humidity sensitivity based on multiple process Ni, Qingsheng

372 C p.
article
44 Preparing the In-doped lead-free Cs3Cu2I5 perovskite scintillator by a co-firing technique for its application in high-resolution X-ray imaging Lin, Chengxu

372 C p.
article
45 Real-time data acquisition inside high-pressure PEM water electrolyzer Lee, Chi-Yuan

372 C p.
article
46 Recent advances in bioinspired walking microbots: Design, manufacturing, and challenges Mora-Aquino, Gerardo

372 C p.
article
47 Research on the equivalent impact test method for different pulse widths based on micro-electro-mechanical system devices Chen, Yunan

372 C p.
article
48 Soft origami tripod based on electrohydraulic actuator for multimodal motions Kang, Joohyeon

372 C p.
article
49 Soft robotic grippers: A review on technologies, materials, and applications AboZaid, Yahia A.

372 C p.
article
50 Temperature-compensated high-sensitivity refractive index, liquid level and PH sensing realization enabled by a small-period microfiber long period grating cascaded with microfiber Bragg grating Li, Hongtao

372 C p.
article
51 Temperature sensing materials based on the fluorescence intensity ratio in Li2Ba5W3O15:Dy3+ phosphors Anu,

372 C p.
article
52 The driving characteristics of bidirectional SMA wire actuators - Theoretical modeling and experimental testing Pei, Yong-Chen

372 C p.
article
53 The linear response of composite pressure sensors by controlling effective volumetric filler concentration Bae, Seonghyun

372 C p.
article
54 Towards the fabrication of fully printed flexible P(VDF-TrFE)-based piezoelectric sensors Miranda, Bárbara H.S.

372 C p.
article
55 Trap-assisted tunneling in type II Ag2O/β-Ga2O3 self-powered solar blind photodetector Labed, Madani

372 C p.
article
56 Two-dimensional van der Waals heterostructure for ultra-sensitive nanoelectromechanical piezoresistive pressure sensing Zeng, Haiou

372 C p.
article
57 Uniform optically pumped spin-exchange relaxation-free comagnetometer based on optical compensation Yuan, Linlin

372 C p.
article
58 Using multi-criteria decision-making approach for material alternatives in TiO2/P(VDF-TrFE)/PDMS based hybrid nanogenerator as a wearable device Kumar, Mukesh

372 C p.
article
59 Wettability-patterned PDMS surface with high adhesion for multifunctional droplet transferring manipulation Li, Xiaoping

372 C p.
article
                             59 results found
 
 Koninklijke Bibliotheek - National Library of the Netherlands