Digitale Bibliotheek
Sluiten Bladeren door artikelen uit een tijdschrift
 
Zoeken naar met titel:
ABCDEFGHIJKLMNOPQRSTUVWXYZ

     Tijdschrift beschrijving
       Alle jaargangen van het bijbehorende tijdschrift
         Alle afleveringen van het bijbehorende jaargang
                                       Alle artikelen van de bijbehorende aflevering
 
                             56 gevonden resultaten
nr titel auteur tijdschrift jaar jaarg. afl. pagina('s) type
1 A multiscale approach for the deformation mechanism in pearlite microstructure: Numerical evaluation of elasto-plastic deformation in fine lamellar structures Ohashi, Tetsuya
 2013
 588 C p. 214-220
7 p.
 artikel
2 Anisotropy of uni-axial and bi-axial deformation behavior of pure Titanium after hydrostatic extrusion Moreno-Valle, E.C.
 2013
 588 C p. 7-13
7 p.
 artikel
3 A systematic investigation of fracture mechanisms in Al–Si based eutectic alloy—Effect of Si modification Joseph, Sudha
 2013
 588 C p. 111-124
14 p.
 artikel
4 Author Index 2013
 588 C p. 432-434
3 p.
 artikel
5 Carbides and mechanical properties in a Fe–Cr–Ni–Mo high-strength steel with different V contents Wen, Tao
 2013
 588 C p. 201-207
7 p.
 artikel
6 Combinative hardening effects of precipitation in a commercial aged Al–Cu–Li–X alloy Chen, Zhongwei
 2013
 588 C p. 59-64
6 p.
 artikel
7 Creep behavior of two Cu-2vol% TiC alloys obtained by reaction milling and extrusion Palma, Rodrigo H.
 2013
 588 C p. 82-85
4 p.
 artikel
8 Determination of creep properties of a P91 weldment by small punch testing and a new evaluation approach Gülçimen, B.
 2013
 588 C p. 125-131
7 p.
 artikel
9 Editorial Board 2013
 588 C p. IFC-
1 p.
 artikel
10 Effect of calcium addition on the hot working behavior of as-cast AZ31 magnesium alloy Suresh, K.
 2013
 588 C p. 272-279
8 p.
 artikel
11 Effect of creep-aging on precipitates of 7075 aluminum alloy Lin, Y.C.
 2013
 588 C p. 347-356
10 p.
 artikel
12 Effect of cryogenic treatment on the microstructure and mechanical properties of Mg–1.5Zn–0.15Gd magnesium alloy Liu, Yong
 2013
 588 C p. 76-81
6 p.
 artikel
13 Effect of extrusion conditions on microstructure and mechanical properties of microalloyed Mg–Sn–Al–Zn alloys Elsayed, F.R.
 2013
 588 C p. 318-328
11 p.
 artikel
14 Effect of mechanical tension on corrosive and thermal properties of Cu50Zr40Ti10 metallic glass Cai, A.H.
 2013
 588 C p. 49-58
10 p.
 artikel
15 Effect of microstructural evolution on high-temperature strength of 9Cr–3W–3Co martensitic heat resistant steel under different aging conditions Yan, Peng
 2013
 588 C p. 22-28
7 p.
 artikel
16 Effect of strain ratio on cyclic deformation behavior of a rare-earth containing extruded magnesium alloy Mirza, F.A.
 2013
 588 C p. 250-259
10 p.
 artikel
17 Effect of stress-induced α″ martensite on Young's modulus of β Ti–33.6Nb–4Sn alloy Hanada, Shuji
 2013
 588 C p. 403-410
8 p.
 artikel
18 Effect of Ta substitution method on the mechanical properties of Ni3(Si,Ti) intermetallic alloy Imajo, Daiki
 2013
 588 C p. 228-238
11 p.
 artikel
19 Effects of rare earth Er addition on microstructure and mechanical properties of hypereutectic Al–20% Si alloy Li, Qinglin
 2013
 588 C p. 97-102
6 p.
 artikel
20 Enhanced mechanical properties in diamond/Cu composites with chromium carbide coating for structural applications Zhao, Chao
 2013
 588 C p. 221-227
7 p.
 artikel
21 Enhancing the stability of β phase in TiZr via severe plastic deformation Zhang, Zhibo
 2013
 588 C p. 416-419
4 p.
 artikel
22 Failure mechanisms in DP600 steel: Initiation, evolution and fracture Ghadbeigi, H.
 2013
 588 C p. 420-431
12 p.
 artikel
23 Hot shortness behavior of a copper-alloyed high strength interstitial free steel Rana, R.
 2013
 588 C p. 288-298
11 p.
 artikel
24 Hydrogen enhanced fatigue crack growth in an HSLA steel Roy, Arijit
 2013
 588 C p. 86-96
11 p.
 artikel
25 Improvement of high temperature fatigue lifetime in AZ91 magnesium alloy by heat treatment Mokhtarishirazabad, Mehdi
 2013
 588 C p. 357-365
9 p.
 artikel
26 Inconel 939 processed by selective laser melting: Effect of microstructure and temperature on the mechanical properties under static and cyclic loading Kanagarajah, P.
 2013
 588 C p. 188-195
8 p.
 artikel
27 Influence of microstructure on local intra- and intergranular deformations during creep of a nickel-based superalloy at 700°C Thibault, Kevin
 2013
 588 C p. 14-21
8 p.
 artikel
28 Influence of nitrogen alloying on properties of Fe318Cr312Mn3XN austenitic stainless steels Behjati, P.
 2013
 588 C p. 43-48
6 p.
 artikel
29 Influence of post-weld hot rolling on the microstructure and mechanical properties of AZ31 magnesium alloy sheet Chai, Sensen
 2013
 588 C p. 208-213
6 p.
 artikel
30 In situ observation of high temperature tensile deformation and low cycle fatigue response in a nickel-base superalloy Lu, Xudong
 2013
 588 C p. 411-415
5 p.
 artikel
31 Mechanical behavior of FCC single crystals at finite temperatures in the presence of point defects Salehinia, I.
 2013
 588 C p. 340-346
7 p.
 artikel
32 Microstructural homogenization of ECAPed copper through post-rolling Ranjbar Bahadori, Sh.
 2013
 588 C p. 260-264
5 p.
 artikel
33 Microstructure and mechanical properties of friction stir welded joint of Zr46Cu46Al8 bulk metallic glass with pure aluminum Li, F.P.
 2013
 588 C p. 196-200
5 p.
 artikel
34 Microstructure and mechanical properties of milled fibre/SiC multilayer composites prepared by tape casting and pressureless sintering Yang, W.S.
 2013
 588 C p. 103-110
8 p.
 artikel
35 Microstructure and mechanical properties of TiC0.5 reinforced copper matrix composites Li, Mengqi
 2013
 588 C p. 335-339
5 p.
 artikel
36 Microstructure evolution and mechanical properties of 7A09 high strength aluminium alloy processed by backward extrusion at room temperature Chen, Qiang
 2013
 588 C p. 395-402
8 p.
 artikel
37 Microstructures and mechanical properties of heat-treated Al–5.0Cu–0.5Fe squeeze cast alloys with different Mn/Fe ratio Zhang, Weiwen
 2013
 588 C p. 366-375
10 p.
 artikel
38 Optimizing the strength and ductility of AZ91 Mg alloy by ECAP and subsequent aging Yuan, Yuchun
 2013
 588 C p. 329-334
6 p.
 artikel
39 Precipitation behavior of nanoscale cementite in 0.17% carbon steel during ultra fast cooling (UFC) and thermomechanical treatment (TMT) Wang, Bin
 2013
 588 C p. 167-174
8 p.
 artikel
40 Properties of cryo-drawn copper with severely twinned microstructure Kauffmann, A.
 2013
 588 C p. 132-141
10 p.
 artikel
41 Quantitative study of precipitates in an Al–Zn–Mg–Cu alloy aged with various typical tempers Liu, Dongmei
 2013
 588 C p. 1-6
6 p.
 artikel
42 Reduction of environmentally induced cracking of laser-welded shape memory NiTi wires via post-weld heat-treatment Chan, C.W.
 2013
 588 C p. 388-394
7 p.
 artikel
43 Research on damage evolution and damage model of 316LN steel during forging Duan, X.W.
 2013
 588 C p. 265-271
7 p.
 artikel
44 SAP-like ultrafine-grained Al composites dispersion strengthened with nanometric AlN Balog, M.
 2013
 588 C p. 181-187
7 p.
 artikel
45 Slip transmission in bcc FeCr polycrystal Patriarca, Luca
 2013
 588 C p. 308-317
10 p.
 artikel
46 Study of Lüders phenomena in reactor pressure vessel steels Beardsmore, D.W.
 2013
 588 C p. 151-166
16 p.
 artikel
47 Subject Index 2013
 588 C p. 435-441
7 p.
 artikel
48 Texture development during deformation processing of the n-type bismuth telluride alloy Bi2Se0.3Te2.7 Srinivasan, Raghavan
 2013
 588 C p. 376-387
12 p.
 artikel
49 Texture evolution in TLM titanium alloy during uniaxial compression Bai, X.F.
 2013
 588 C p. 29-33
5 p.
 artikel
50 The effect of pre-ageing temperature and retrogression heating rate on the microstructure and properties of AA7055 Feng, D.
 2013
 588 C p. 34-42
9 p.
 artikel
51 The effect of stoichiometry on the microstructural evolution during ordering of Ni3V Fujioka, Kouki
 2013
 588 C p. 239-249
11 p.
 artikel
52 The influence of Nb on transformation behavior and mechanical properties of TRIP-assisted bainitic–ferritic sheet steels Hausmann, K.
 2013
 588 C p. 142-150
9 p.
 artikel
53 The precipitation behavior of an Al–Cu–Mg–Ag alloy under ECAP Gazizov, M.
 2013
 588 C p. 65-75
11 p.
 artikel
54 Thermal shock behavior of porous ZrB2–SiC ceramics Jin, Xinxin
 2013
 588 C p. 175-180
6 p.
 artikel
55 Twinning and martensitic transformations in nickel-enriched 304 austenitic steel during tensile and indentation deformations Gussev, M.N.
 2013
 588 C p. 299-307
9 p.
 artikel
56 Using an Al–Cu binary alloy to compare processing by multi-axial compression and high-pressure torsion Xu, Xiaochang
 2013
 588 C p. 280-287
8 p.
 artikel
                             56 gevonden resultaten
 
 Koninklijke Bibliotheek - Nationale Bibliotheek van Nederland