nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
A comparative embodied energy analysis of a house with recycled expanded polystyrene (EPS) based foam concrete wall panels
|
Dissanayake, D.M.K.W. |
|
2017 |
135 |
C |
p. 85-94 |
artikel |
2 |
A context-awareness system that uses a thermographic camera to monitor energy waste in buildings
|
Lee, Chijoo |
|
2017 |
135 |
C |
p. 148-155 |
artikel |
3 |
A field study of thermal comfort performance for a slotted louvre ventilation system in a low energy retrofit
|
O’Donovan, Adam |
|
2017 |
135 |
C |
p. 312-323 |
artikel |
4 |
A generalised model of electrical energy demand from small household appliances
|
Sancho-Tomás, A. |
|
2017 |
135 |
C |
p. 350-366 |
artikel |
5 |
A multistage stochastic energy model with endogenous probabilities and a rolling horizon
|
Champion, Billy R. |
|
2017 |
135 |
C |
p. 338-349 |
artikel |
6 |
Analysis of the performance of a tankless water heating combo system: Simultaneous space heating and domestic hot water operation
|
Der, Joseph P. |
|
2017 |
135 |
C |
p. 50-61 |
artikel |
7 |
Application of the malfunction thermoeconomic diagnosis to a dynamic heating and DHW facility for fault detection
|
Picallo-Perez, Ana |
|
2017 |
135 |
C |
p. 385-397 |
artikel |
8 |
A rapid evaluation method of existing building applied photovoltaic (BAPV) potential
|
Zhang, Wen |
|
2017 |
135 |
C |
p. 39-49 |
artikel |
9 |
Assessing the impacts of real-time occupancy state transitions on building heating/cooling loads
|
Yang, Zheng |
|
2017 |
135 |
C |
p. 201-211 |
artikel |
10 |
Balance point temperature for heating as a function of glazing orientation and room time constant
|
Verbai, Zoltán |
|
2017 |
135 |
C |
p. 1-9 |
artikel |
11 |
Building thermal design for solar photovoltaic air-conditioning in Australian climates
|
Goldsworthy, M.J. |
|
2017 |
135 |
C |
p. 176-186 |
artikel |
12 |
Characterizing variations in variable air volume system controls
|
Pang, Xiufeng |
|
2017 |
135 |
C |
p. 166-175 |
artikel |
13 |
Coupled heat and moisture transfer in hollow concrete block wall filled with compressed straw bricks
|
Hou, Shaodan |
|
2017 |
135 |
C |
p. 74-84 |
artikel |
14 |
Development and validation of an intelligent load control algorithm
|
Kim, Woohyun |
|
2017 |
135 |
C |
p. 62-73 |
artikel |
15 |
Development of an automatic calibration method of a VRF energy model for the design of energy efficient buildings
|
Yun, Geun Young |
|
2017 |
135 |
C |
p. 156-165 |
artikel |
16 |
Editorial Board
|
|
|
2017 |
135 |
C |
p. IFC |
artikel |
17 |
Energy and indoor environmental performance of typical Egyptian offices: Survey, baseline model and uncertainties
|
Elharidi, Aly M. |
|
2017 |
135 |
C |
p. 367-384 |
artikel |
18 |
Energy performance of a medium scale green roof system installed on a commercial building using numerical and experimental data recorded during the cold period of the year
|
Foustalieraki, M. |
|
2017 |
135 |
C |
p. 33-38 |
artikel |
19 |
Energy transfer and energy saving potentials of air-to-air membrane energy exchanger for ventilation in cold climates
|
Liu, Peng |
|
2017 |
135 |
C |
p. 95-108 |
artikel |
20 |
Experimental study on the thermal performance of an enhanced-convection overhead radiant floor heating system
|
Wang, Dengjia |
|
2017 |
135 |
C |
p. 233-243 |
artikel |
21 |
Heat source discrimination in buildings to reconstruct internal gains from temperature measurements
|
Brouns, Jordan |
|
2017 |
135 |
C |
p. 253-262 |
artikel |
22 |
Improving transient thermal simulations of single dwellings using interpolated weather data
|
Eguía Oller, Pablo |
|
2017 |
135 |
C |
p. 212-224 |
artikel |
23 |
Inferring the thermal resistance and effective thermal mass distribution of a wall from in situ measurements to characterise heat transfer at both the interior and exterior surfaces
|
Gori, Virginia |
|
2017 |
135 |
C |
p. 398-409 |
artikel |
24 |
Influence of internal heat sources on thermal resistance evaluation through the heat flow meter method
|
Guattari, Claudia |
|
2017 |
135 |
C |
p. 187-200 |
artikel |
25 |
Infrared thermography technique as an in-situ method of assessing heat loss through thermal bridging
|
O’Grady, Małgorzata |
|
2017 |
135 |
C |
p. 20-32 |
artikel |
26 |
Life cycle assessment (LCA) of building refurbishment: A literature review
|
Vilches, Alberto |
|
2017 |
135 |
C |
p. 286-301 |
artikel |
27 |
Modelling and experimental determination of thermal properties of local wet building materials
|
Damfeu, J.C. |
|
2017 |
135 |
C |
p. 109-118 |
artikel |
28 |
Numerical and experimental study of a novel compact micro fluidized beds reactor for CO2 capture in HVAC
|
Li, Xiaofei |
|
2017 |
135 |
C |
p. 128-136 |
artikel |
29 |
Prediction method of real discount rate to improve accuracy of life-cycle cost analysis
|
Lee, Chijoo |
|
2017 |
135 |
C |
p. 225-232 |
artikel |
30 |
Reducing energy use for water supply to China’s high-rises
|
Smith, Kate |
|
2017 |
135 |
C |
p. 119-127 |
artikel |
31 |
Statistically informed static pressure control in multiple-zone VAV systems
|
Tukur, Ahmed |
|
2017 |
135 |
C |
p. 244-252 |
artikel |
32 |
Temperature and humidity adaptive control in multi-enclosed thermal zones under unexpected external disturbances
|
Buonomano, Annamaria |
|
2017 |
135 |
C |
p. 263-285 |
artikel |
33 |
Testing the accuracy of low-cost data streams for determining single-person office occupancy and their use for energy reduction of building services
|
Newsham, Guy R. |
|
2017 |
135 |
C |
p. 137-147 |
artikel |
34 |
The effect of dynamic solar shading on energy, daylighting and thermal comfort in a nearly zero-energy loft room in Rome and Copenhagen
|
Skarning, Gunnlaug Cecilie Jensen |
|
2017 |
135 |
C |
p. 302-311 |
artikel |
35 |
The effect of living wall systems on the thermal resistance of the façade
|
Tudiwer, David |
|
2017 |
135 |
C |
p. 10-19 |
artikel |
36 |
Will cool roofs improve the thermal performance of our built environment? A study assessing roof systems in Bahrain
|
Radhi, Hassan |
|
2017 |
135 |
C |
p. 324-337 |
artikel |