| no |
title |
author |
magazine |
year |
volume |
issue |
page(s) |
type |
| 1 |
Antimicrobial properties of protective coatings produced by plasma spraying technique
|
Wrona, A.
|
|
2017
|
318 |
C |
p. 332-340
9 p.
|
article
|
| 2 |
Bioactive glass coatings by suspension plasma spraying from glycolether-based solvent feedstock
|
Cañas, E.
|
|
2017
|
318 |
C |
p. 190-197
8 p.
|
article
|
| 3 |
Characterization of duplex coating system (HVOF+PVD) on light alloy substrates
|
Picas, J.A.
|
|
2017
|
318 |
C |
p. 326-331
6 p.
|
article
|
| 4 |
Chlorine-induced high temperature corrosion of Inconel 625 sprayed coatings deposited with different thermal spray techniques
|
Fantozzi, Davide
|
|
2017
|
318 |
C |
p. 233-243
11 p.
|
article
|
| 5 |
Comparison of oxidation behavior of YSZ and Gd2Zr2O7 thermal barrier coatings (TBCs)
|
Doleker, Kadir Mert
|
|
2017
|
318 |
C |
p. 198-207
10 p.
|
article
|
| 6 |
Comparison of tribological properties of HVOF sprayed coatings with different composition
|
Karaoglanli, Abdullah Cahit
|
|
2017
|
318 |
C |
p. 299-308
10 p.
|
article
|
| 7 |
Correlation of splat morphologies with porosity and residual stress in plasma-sprayed YSZ coatings
|
Mutter, Markus
|
|
2017
|
318 |
C |
p. 157-169
13 p.
|
article
|
| 8 |
Corrosion protection and electrical conductivity of copper coatings deposited by low-pressure cold spraying
|
Winnicki, M.
|
|
2017
|
318 |
C |
p. 90-98
9 p.
|
article
|
| 9 |
Development of hydroxyapatite coatings by solution precursor plasma spray process and their microstructural characterization
|
Candidato Jr., Rolando T.
|
|
2017
|
318 |
C |
p. 39-49
11 p.
|
article
|
| 10 |
Development of plasma sprayed Ni/YSZ anodes for metal supported solid oxide fuel cells
|
Gupta, M.
|
|
2017
|
318 |
C |
p. 178-189
12 p.
|
article
|
| 11 |
Diagnostic of laser remelting of HVOF sprayed Stellite coatings using an infrared camera
|
Vostřák, Marek
|
|
2017
|
318 |
C |
p. 360-364
5 p.
|
article
|
| 12 |
Editorial Board
|
|
|
2017
|
318 |
C |
p. IFC-
1 p.
|
article
|
| 13 |
Effect of alumina-silica-zirconia eutectic ceramic thermal barrier coating on the low cycle fatigue behaviour of cast polycrystalline nickel-based superalloy at 900°C
|
Obrtlík, Karel
|
|
2017
|
318 |
C |
p. 374-381
8 p.
|
article
|
| 14 |
Effect of long-term heat-treatment at 1150°C on the microstructure and properties of thermal barrier coatings based on ZrO2–4mol.% Y2O3–1mol.% Gd2O3–1mol.% Yb2O3
|
Bobzin, Kirsten
|
|
2017
|
318 |
C |
p. 142-146
5 p.
|
article
|
| 15 |
Effect of nano-sized TiC powder on microstructure and the corrosion resistance of WC-Co thermal spray coatings
|
Myalska, H.
|
|
2017
|
318 |
C |
p. 270-278
9 p.
|
article
|
| 16 |
Effects of laser remelting process on the microstructure, roughness and microhardness of in-situ cold sprayed hypoeutectic Al-Si coating
|
Kang, Nan
|
|
2017
|
318 |
C |
p. 355-359
5 p.
|
article
|
| 17 |
Enhancing the properties of WC/Co detonation coatings using two-component fuels
|
Ulianitsky, V.
|
|
2017
|
318 |
C |
p. 244-249
6 p.
|
article
|
| 18 |
Functional performance of Gd2Zr2O7/YSZ multi-layered thermal barrier coatings deposited by suspension plasma spray
|
Mahade, Satyapal
|
|
2017
|
318 |
C |
p. 208-216
9 p.
|
article
|
| 19 |
Gas and liquid-fuelled HVOF spraying of Ni50Cr coating: Microstructure and high temperature oxidation
|
Song, B.
|
|
2017
|
318 |
C |
p. 224-232
9 p.
|
article
|
| 20 |
Impact of processing conditions and feedstock characteristics on thermally sprayed MCrAlY bondcoat properties
|
Mauer, Georg
|
|
2017
|
318 |
C |
p. 114-121
8 p.
|
article
|
| 21 |
Influence of cold spray parameters on the microstructures and residual stress of Zn coatings sprayed on mild steel
|
Maledi, N.B.
|
|
2017
|
318 |
C |
p. 106-113
8 p.
|
article
|
| 22 |
Investigation on the influence of particle preheating temperature on bonding of cold-sprayed nickel coatings
|
Xie, Yingchun
|
|
2017
|
318 |
C |
p. 99-105
7 p.
|
article
|
| 23 |
Isothermal oxidation behavior and kinetics of thermal barrier coatings produced by cold gas dynamic spray technique
|
Karaoglanli, Abdullah Cahit
|
|
2017
|
318 |
C |
p. 72-81
10 p.
|
article
|
| 24 |
Kinetics of composite coating formation process in cold spray: Modelling and experimental validation
|
Sova, A.
|
|
2017
|
318 |
C |
p. 309-314
6 p.
|
article
|
| 25 |
Low power consumption suspension plasma spray system for ceramic coating deposition
|
Shahien, Mohammed
|
|
2017
|
318 |
C |
p. 11-17
7 p.
|
article
|
| 26 |
Manufacturing of high performance solid oxide fuel cells (SOFCs) with atmospheric plasma spraying (APS) and plasma spray-physical vapor deposition (PS-PVD)
|
Marcano, D.
|
|
2017
|
318 |
C |
p. 170-177
8 p.
|
article
|
| 27 |
Microstructural characteristics and corrosion behavior of HVAF- and HVOF-sprayed Fe-based coatings
|
Sadeghimeresht, E.
|
|
2017
|
318 |
C |
p. 365-373
9 p.
|
article
|
| 28 |
Microstructure and electric properties of low-pressure plasma sprayed β-FeSi2 based coatings
|
Feng, X.
|
|
2017
|
318 |
C |
p. 3-10
8 p.
|
article
|
| 29 |
Microstructure and performance of cold sprayed Al-SiC composite coatings with high fraction of particulates
|
Kumar, S.
|
|
2017
|
318 |
C |
p. 62-71
10 p.
|
article
|
| 30 |
Microstructure and sliding wear properties of HVOF sprayed, laser remelted and laser clad Stellite 6 coatings
|
Houdková, Šárka
|
|
2017
|
318 |
C |
p. 129-141
13 p.
|
article
|
| 31 |
Modelling of coating thickness distribution and its application in offline programming software
|
Chen, C.
|
|
2017
|
318 |
C |
p. 315-325
11 p.
|
article
|
| 32 |
Novel Fe-based wear and corrosion resistant coatings by three-cathode plasma technology
|
Bobzin, Kirsten
|
|
2017
|
318 |
C |
p. 288-292
5 p.
|
article
|
| 33 |
Numerical and experimental analysis of molten pool dimensions and residual stresses of NiCrBSi coating treated by laser post-remelting
|
Liu, Jiangwei
|
|
2017
|
318 |
C |
p. 341-348
8 p.
|
article
|
| 34 |
Performance of cold sprayed Ni based coatings in actual boiler environment
|
Bala, Niraj
|
|
2017
|
318 |
C |
p. 50-61
12 p.
|
article
|
| 35 |
Plasma-sprayed Mo-Re coatings for glass industry applications
|
Osadnik, Małgorzata
|
|
2017
|
318 |
C |
p. 349-354
6 p.
|
article
|
| 36 |
Possibility of spraying of copper coatings on polyamide 6 with low pressure cold spray method
|
Małachowska, Aleksandra
|
|
2017
|
318 |
C |
p. 82-89
8 p.
|
article
|
| 37 |
Preface
|
Pawłowski, Lech
|
|
2017
|
318 |
C |
p. 1-2
2 p.
|
article
|
| 38 |
Residual stresses and corrosion performance of plasma sprayed zinc-based alloy coating on mild steel substrate
|
Mathabatha, M.H.
|
|
2017
|
318 |
C |
p. 293-298
6 p.
|
article
|
| 39 |
STEM analysis of WC-Co coatings modified by nano-sized TiC and nano-sized WC addition
|
Myalska, H.
|
|
2017
|
318 |
C |
p. 279-287
9 p.
|
article
|
| 40 |
Suspension and precursor solution plasma spraying by means of synchronous injection in a pulsed arc plasma
|
Mavier, Fabrice
|
|
2017
|
318 |
C |
p. 18-27
10 p.
|
article
|
| 41 |
Synthesis and characterization of nanocrystalline Al2O3-Ni(Cr) particles using high-energy mechanical alloying process
|
Nath, Lipika
|
|
2017
|
318 |
C |
p. 262-269
8 p.
|
article
|
| 42 |
The application of photoluminescence piezospectroscopy for residual stresses measurement in thermally sprayed TBCs
|
Lima, C.R.C.
|
|
2017
|
318 |
C |
p. 147-156
10 p.
|
article
|
| 43 |
The influence of substrate temperature and spraying distance on the properties of plasma sprayed tungsten and steel coatings deposited in a shrouding chamber
|
Matějíček, Jiří
|
|
2017
|
318 |
C |
p. 217-223
7 p.
|
article
|
| 44 |
The microstructural studies of suspension plasma sprayed zirconia coatings with the use of high-energy plasma torches
|
Sokołowski, Paweł
|
|
2017
|
318 |
C |
p. 250-261
12 p.
|
article
|
| 45 |
Thermal insulation properties of YSZ coatings: Suspension Plasma Spraying (SPS) versus Electron Beam Physical Vapor Deposition (EB-PVD) and Atmospheric Plasma Spraying (APS)
|
Bernard, Benjamin
|
|
2017
|
318 |
C |
p. 122-128
7 p.
|
article
|
| 46 |
Thermophysical properties of YSZ and YCeSZ suspension plasma sprayed coatings having different microstructures
|
Sokołowski, Paweł
|
|
2017
|
318 |
C |
p. 28-38
11 p.
|
article
|
Journal description