Digitale Bibliotheek
Sluiten Bladeren door artikelen uit een tijdschrift
     Tijdschrift beschrijving
       Alle jaargangen van het bijbehorende tijdschrift
         Alle afleveringen van het bijbehorende jaargang
                                       Alle artikelen van de bijbehorende aflevering
 
                             65 gevonden resultaten
nr titel auteur tijdschrift jaar jaarg. afl. pagina('s) type
1 AlNx and a-SiOx coatings with corrosion resistance properties for dental implants Gazia, Rossana
2011
206 6 p. 1109-1115
7 p.
artikel
2 A novel surface activation method for Ni/Au electroless plating of acrylonitrile–butadiene–styrene Tang, Xuejiao
2011
206 6 p. 1382-1388
7 p.
artikel
3 Antifogging and antireflective silica film and its application on solar modules Lu, Xiaoying
2011
206 6 p. 1490-1494
5 p.
artikel
4 An XPS and ellipsometry study of Cr–O–Al mixed oxides grown by reactive magnetron sputtering Benito, N.
2011
206 6 p. 1484-1489
6 p.
artikel
5 A study of electroless copper–phosphorus coatings with the addition of silicon carbide (SiC) and graphite (Cg) particles Faraji, Soheila
2011
206 6 p. 1259-1268
10 p.
artikel
6 Cathodic arc deposition of (Al,Cr)2O3: Macroparticles and cathode surface modifications Pohler, M.
2011
206 6 p. 1454-1460
7 p.
artikel
7 Cathodic arc plasma deposition of nano-multilayered ZrN/AlSiN thin films Kim, Sun Kyu
2011
206 6 p. 1507-1510
4 p.
artikel
8 Corrosion properties of thermally annealed and co-sputtered nickel silicide thin films Tam, P.L.
2011
206 6 p. 1160-1167
8 p.
artikel
9 Cyclic oxidation behavior and thermal barrier effect of YSZ–(Al2O3/YAG) double-layer TBCs prepared by the composite sol–gel method Ren, C.
2011
206 6 p. 1461-1468
8 p.
artikel
10 Deposition of Ti–6Al–4V using laser and wire, part II: Hardness and dimensions of single beads Brandl, Erhard
2011
206 6 p. 1130-1141
12 p.
artikel
11 Deposition of Ti–6Al–4V using laser and wire, part I: Microstructural properties of single beads Brandl, Erhard
2011
206 6 p. 1120-1129
10 p.
artikel
12 Editorial Board 2011
206 6 p. IFC-
1 p.
artikel
13 Effect of carbide degradation in a Ni-based hardfacing under abrasive and combined impact/abrasive conditions Katsich, C.
2011
206 6 p. 1062-1068
7 p.
artikel
14 Effect of dew point on the surface selective oxidation and subsurface microstructure of TRIP-aided steel Liu, Huachu
2011
206 6 p. 1237-1243
7 p.
artikel
15 Effect of electrolyte pH and Cu concentration on microstructure of electrodeposited Ni–Cu alloy films Haciismailoglu, Murside
2011
206 6 p. 1430-1438
9 p.
artikel
16 Effect of porosity sealing treatments on the corrosion resistance of high-velocity oxy-fuel (HVOF)-sprayed Fe-based amorphous metallic coatings Wang, Y.
2011
206 6 p. 1307-1318
12 p.
artikel
17 Effect of substrate temperature on the splat formation of flame sprayed polypropylene Alamara, Kadhim
2011
206 6 p. 1180-1187
8 p.
artikel
18 Effects of graphite content on the microstructure and wear properties of an AISI 8620 steel surface modified by tungsten inert gas (TIG) Çelik, Osman Nuri
2011
206 6 p. 1423-1429
7 p.
artikel
19 Effects of heating temperature and duration on the microstructure and properties of the self-healing coatings Gao, Jifeng
2011
206 6 p. 1342-1350
9 p.
artikel
20 Enhancing visible-light activity of the self-cleaning TiO2-coated cotton fabrics by loading AgI particles Wu, Deyong
2011
206 6 p. 1175-1179
5 p.
artikel
21 First step of anodization influences the final nanopore arrangement in anodized alumina Stępniowski, Wojciech J.
2011
206 6 p. 1416-1422
7 p.
artikel
22 High-temperature tribological properties of CrAlN, CrAlSiN and AlCrSiN coatings Polcar, Tomas
2011
206 6 p. 1244-1251
8 p.
artikel
23 Improving adhesion of electroless Ni–P coating on sintered NdFeB magnet Wang, Yao
2011
206 6 p. 1203-1210
8 p.
artikel
24 Incorporation of amino moieties through atmospheric pressure plasma: Relationship between precursor structure and coating properties Dubreuil, M.F.S.
2011
206 6 p. 1439-1448
10 p.
artikel
25 Influence of gas flow on argon microwave plasma jet at atmospheric pressure Iio, Shouichiro
2011
206 6 p. 1449-1453
5 p.
artikel
26 Influence of nitrogen background pressure on structure of niobium nitride films grown by pulsed laser deposition Farha, Ashraf H.
2011
206 6 p. 1168-1174
7 p.
artikel
27 Influence of SiO2/Na2O ratio and temperature on the mechanism of interaction of soluble sodium silicates with porous anodic alumina Gaggiano, R.
2011
206 6 p. 1269-1276
8 p.
artikel
28 Inhibition of molten droplet deposition by substrate surface hydroxides Tran, A.T.T.
2011
206 6 p. 1283-1292
10 p.
artikel
29 Investigations of Mn–Co–O and Mn–Co–Y–O coatings deposited by the magnetron sputtering on ferritic stainless steels Gavrilov, N.V.
2011
206 6 p. 1252-1258
7 p.
artikel
30 Iridium coating prepared on rhenium substrate by electrodeposition in molten salt in the air atmosphere Zhu, Li'an
2011
206 6 p. 1351-1354
4 p.
artikel
31 Mechanical properties and antibacterial activity of copper doped diamond-like carbon films Chan, Yu-Hao
2011
206 6 p. 1037-1040
4 p.
artikel
32 Mechanical response of amorphous ZrCuTi/PdCuSi nanolaminates under nanoindentation Kuan, S.Y.
2011
206 6 p. 1116-1119
4 p.
artikel
33 Microstructure and corrosion behavior of the AISI 304 stainless steel after Nd:YAG pulsed laser surface melting Cui, C.Y.
2011
206 6 p. 1146-1154
9 p.
artikel
34 Microstructure and fatigue properties of plasma transferred arc alloying TiC-W-Cr on gray cast iron Shi, Kaiyuan
2011
206 6 p. 1211-1217
7 p.
artikel
35 Microstructure and mechanical properties of Al2O3–Cr2O3 composite coatings produced by atmospheric plasma spraying Yang, Kai
2011
206 6 p. 1362-1371
10 p.
artikel
36 Microstructure and sliding wear behavior of nanostructured Ni60–TiB2 composite coating sprayed by HVOF technique Wu, Y.S.
2011
206 6 p. 1102-1108
7 p.
artikel
37 Microstructure and tribological properties of diamond-like carbon and TiAlSiCN nanocomposite coatings Xie, Z.W.
2011
206 6 p. 1293-1298
6 p.
artikel
38 Microstructure and wear resistance of oxide coatings on Ti–6Al–4V produced by plasma electrolytic oxidation in an inexpensive electrolyte Khorasanian, M.
2011
206 6 p. 1495-1502
8 p.
artikel
39 Modification of polytetrafluoroethylene implants by depositing TiCaPCON films with and without stem cells Shtansky, D.V.
2011
206 6 p. 1188-1195
8 p.
artikel
40 On surface temperatures during high power pulsed magnetron sputtering using a hot target Tesař, J.
2011
206 6 p. 1155-1159
5 p.
artikel
41 Optimization of the Scratch Test for specific coating designs Schwarzer, N.
2011
206 6 p. 1327-1335
9 p.
artikel
42 Oxidation resistance and corrosion behavior of hot-dip aluminized coatings on commercial-purity titanium Wang, Yuansheng
2011
206 6 p. 1277-1282
6 p.
artikel
43 Partially amorphous stainless steel coatings: Microstructure, annealing behavior and statistical optimization of spray parameters Zois, D.
2011
206 6 p. 1469-1483
15 p.
artikel
44 Photocatalytic activity of anatase-containing facade coatings Marolt, Tina
2011
206 6 p. 1355-1361
7 p.
artikel
45 Plasma polymerization of amine-containing thin films and the studies on the deposition kinetics Mangindaan, Dave
2011
206 6 p. 1299-1306
8 p.
artikel
46 Powder stream characteristics in cold spray nozzles Lupoi, R.
2011
206 6 p. 1069-1076
8 p.
artikel
47 Preparation of nickel-coated tungsten carbide powders by room temperature ultrasonic-assisted electroless plating Luo, Laima
2011
206 6 p. 1091-1095
5 p.
artikel
48 Reactive pulsed laser deposition and characterization of niobium nitride thin films Krishnan, R.
2011
206 6 p. 1196-1202
7 p.
artikel
49 Residual stress in thermal spray coatings measured by curvature based on 3D digital image correlation technique Zhu, Jianguo
2011
206 6 p. 1396-1402
7 p.
artikel
50 Room temperature process for chemical vapor deposition of amorphous silicon carbide thin film using monomethylsilane gas Habuka, Hitoshi
2011
206 6 p. 1503-1506
4 p.
artikel
51 Self-similar scaling of discharge events through PEO coatings on aluminium Dunleavy, C.S.
2011
206 6 p. 1051-1061
11 p.
artikel
52 Simultaneous plasma-electrolytic anodic oxidation (PAO) of Al–Mg compounds Alisch, G.
2011
206 6 p. 1085-1090
6 p.
artikel
53 Spray deposited superhydrophobic ZnO coatings via seed assisted growth Tarwal, N.L.
2011
206 6 p. 1336-1341
6 p.
artikel
54 Surface modification of acrylonitrile-butadiene-styrene (ABS) with heterogeneous photocatalysis (TiO2) for the substitution of the etching stage in the electroless process Magallón-Cacho, L.
2011
206 6 p. 1410-1415
6 p.
artikel
55 Surface modification of austenitic stainless steel with plasma nitriding for biomedical applications Ou, Keng-Liang
2011
206 6 p. 1142-1145
4 p.
artikel
56 Synthesis and characterization of (0001)-textured wurtzite Al1-xBxN thin films Liljeholm, L.
2011
206 6 p. 1033-1036
4 p.
artikel
57 Synthesis and protection of AM50 magnesium alloy and its composites using environmentally pretreatment electrolyte Hamid, Z. Abdel
2011
206 6 p. 1041-1050
10 p.
artikel
58 Synthesis of Fe–Ni–B–Si–Nb amorphous and crystalline composite coatings by laser cladding and remelting Zhang, Peilei
2011
206 6 p. 1229-1236
8 p.
artikel
59 Synthesis of Hf-modified aluminide coatings on Co-base superalloys Wang, YongQing
2011
206 6 p. 1403-1409
7 p.
artikel
60 Synthesis of Hf-modified aluminide coatings on Ni-base superalloys Wang, YongQing
2011
206 6 p. 1218-1228
11 p.
artikel
61 The effects of friction-stir process parameters on the fabrication of Ti/SiC nano-composite surface layer Shamsipur, Ali
2011
206 6 p. 1372-1381
10 p.
artikel
62 The effects of heat treatments on hardness and wear resistance in Ni–W alloy coatings Sunwang, Narasak
2011
206 6 p. 1096-1101
6 p.
artikel
63 The production of a multi-walled carbon nanotube/hexamethylene diisocyanate nanocomposite coating on copper by electrophoretic deposition Singh, Bimal P.
2011
206 6 p. 1319-1326
8 p.
artikel
64 Thermal stability and oxidation resistance of laser clad TiVCrAlSi high entropy alloy coatings on Ti–6Al–4V alloy Huang, Can
2011
206 6 p. 1389-1395
7 p.
artikel
65 Tribological behaviour of HVOF sprayed near-nanostructured and microstructured WC-17wt.%Co coatings Mateen, A.
2011
206 6 p. 1077-1084
8 p.
artikel
                             65 gevonden resultaten
 
 Koninklijke Bibliotheek - Nationale Bibliotheek van Nederland