Digital Library
Close Browse articles from a journal
     Journal description
       All volumes of the corresponding journal
         All issues of the corresponding volume
                                       All articles of the corresponding issues
 
                             48 results found
no title author magazine year volume issue page(s) type
1 A comparison of co-current and counter-current modes of operation for a dual-type industrial methanol reactor Rahimpour, M.R.
2008
47 9-10 p. 1819-1830
12 p.
article
2 A mathematical model of extraction in countercurrent crossed flows Veloso, G.O.
2008
47 9-10 p. 1470-1477
8 p.
article
3 A new clean process for barium carbonate preparation by barite reduction with methane Jamshidi, E.
2008
47 9-10 p. 1567-1577
11 p.
article
4 A non-instantaneous kinetic model for freezing in porous media Bronfenbrener, Leonid
2008
47 9-10 p. 1631-1646
16 p.
article
5 A reduced efficiency approach-based process model for a circulating air classifier Eswaraiah, C.
2008
47 9-10 p. 1887-1900
14 p.
article
6 CFD analysis of the flow pattern and local shear rate in a scraped surface heat exchanger Yataghene, Mourad
2008
47 9-10 p. 1550-1561
12 p.
article
7 CFD simulation of the flow field in a bubble column reactor: Importance of the drag force formulation to describe regime transitions Simonnet, M.
2008
47 9-10 p. 1726-1737
12 p.
article
8 Coagulation and flocculation of laterite suspensions with low levels of aluminium chloride and polyacrylamids Dihang, Désiré
2008
47 9-10 p. 1509-1519
11 p.
article
9 Continuous extraction of α-toxin from a fermented broth of Clostridium perfringens Type A in perforated rotating disc contactor using aqueous two-phase PEG–phosphate system Cavalcanti, M.T.H.
2008
47 9-10 p. 1771-1776
6 p.
article
10 Dehydration of tetrahydrofuran (THF) by pervaporation using crosslinked copolymer membranes Ray, S.
2008
47 9-10 p. 1620-1630
11 p.
article
11 Design of a new compact scrubber for deodorisation Couvert, A.
2008
47 9-10 p. 1793-1798
6 p.
article
12 Determination of pressure drop in wire mesh mist eliminator by CFD Rahimi, R.
2008
47 9-10 p. 1504-1508
5 p.
article
13 Determination of the interfacial area of a continuous integrated mixer/separator (CINC) using a chemical reaction method Schuur, B.
2008
47 9-10 p. 1484-1491
8 p.
article
14 Editorial Board 2008
47 9-10 p. CO2-
1 p.
article
15 Effect of a shroud on entrainment into a submerged jet within a fluidized bed Hulet, Craig
2008
47 9-10 p. 1435-1450
16 p.
article
16 Effect of temperature on SO2 absorption into sulphuric acid solutions containing hydrogen peroxide Colle, Sandrine
2008
47 9-10 p. 1603-1608
6 p.
article
17 Effects of influential factors on sedimentation self-assembly processing of photonic band gap crystals by relative humidity-controlled environments Liau, Leo Chau-Kuang
2008
47 9-10 p. 1578-1584
7 p.
article
18 Experimental and numerical heat transfer in a helically baffled heat exchanger combined with one three-dimensional finned tube Zhang, Zhengguo
2008
47 9-10 p. 1738-1743
6 p.
article
19 Experimental and numerical investigations of a dynamic cyclone with a rotary impeller Jiao, Jinyu
2008
47 9-10 p. 1861-1866
6 p.
article
20 Experimental aspects of biomass fuels in a bubbling fluidized bed combustor dos Santos, Francisco José
2008
47 9-10 p. 1541-1549
9 p.
article
21 Experimental behaviour and design model of a continuous tank reactor for removing 4-chlorophenol with soybean peroxidase Gómez, J.L.
2008
47 9-10 p. 1786-1792
7 p.
article
22 Experimental studies on flow and pyrolysis of coal with solid heat carrier in a modified rotating cone reactor Guoxin, Hu
2008
47 9-10 p. 1777-1785
9 p.
article
23 Experimental study of the transition between unsteady flow regimes in a partially aerated two-dimensional bubble column Díaz, M. Elena
2008
47 9-10 p. 1867-1876
10 p.
article
24 Flow models for rectangular sedimentation tanks Rodríguez López, Patricia
2008
47 9-10 p. 1705-1716
12 p.
article
25 Head–flow characteristics of pump-mix mixers Srilatha, C.
2008
47 9-10 p. 1678-1692
15 p.
article
26 Homogenization energy in a stirred tank Ochieng, Aoyi
2008
47 9-10 p. 1853-1860
8 p.
article
27 Hydrodynamic aspects in anaerobic fluidized bed reactor modeling Fuentes, Mauren
2008
47 9-10 p. 1530-1540
11 p.
article
28 Influence of the processing variables on the performance of MAGCLA™: Angle of the trunk and speed of rotation Augusto, Paulo A.
2008
47 9-10 p. 1585-1593
9 p.
article
29 Mathematical modelling of thin-layer infrared drying of wet olive husk Ruiz Celma, A.
2008
47 9-10 p. 1810-1818
9 p.
article
30 Measurements of diffusivity of chlorinated VOCs in heavy absorption solvents using a laminar falling film contactor Hadjoudj, Reda
2008
47 9-10 p. 1478-1483
6 p.
article
31 Mechanism of centrifugal filtration for separation of microbe/protein bio-suspension Hwang, Kuo-Jen
2008
47 9-10 p. 1647-1655
9 p.
article
32 Microwave tempering and heating in a single-mode cavity: Numerical and experimental investigations Curet, S.
2008
47 9-10 p. 1656-1665
10 p.
article
33 Minimising the startup duration for mass- and heat-integrated two-column distillation systems: A conceptual approach Varbanov, P.
2008
47 9-10 p. 1456-1469
14 p.
article
34 Modelling agglomeration degree in sucrose crystallisation Faria, N.
2008
47 9-10 p. 1666-1677
12 p.
article
35 Modelling the removal of mercaptans from liquid hydrocarbon streams in structured packing columns Koncsag, C.I.
2008
47 9-10 p. 1717-1725
9 p.
article
36 On the effect of the orifice configuration on the coalescence of growing bubbles Martín, Mariano
2008
47 9-10 p. 1799-1809
11 p.
article
37 Precipitation of lutein and co-precipitation of lutein and poly-lactic acid with the supercritical anti-solvent process Miguel, F.
2008
47 9-10 p. 1594-1602
9 p.
article
38 Pressure drop of internals for packed columns Rix, A.
2008
47 9-10 p. 1520-1529
10 p.
article
39 Production of high-purity ethyl acetate using reactive distillation: Experimental and start-up procedure Lai, I-Kuan
2008
47 9-10 p. 1831-1843
13 p.
article
40 Recovery of nickel from sulphate media by batch pertraction in a rotating film contactor using Cyanex 302 as a carrier Dimitrov, K.
2008
47 9-10 p. 1562-1566
5 p.
article
41 Recovery of phenolic compounds through the decomposition of lignin in near and supercritical water Wahyudiono,
2008
47 9-10 p. 1609-1619
11 p.
article
42 Selective oxidation of o-xylene to phthalic anhydride over V2O5/TiO2: Kinetic study in a fluidized bed reactor Gimeno, M.P.
2008
47 9-10 p. 1844-1852
9 p.
article
43 Soil remediation via an ionic liquid and supercritical CO2 Keskin, Seda
2008
47 9-10 p. 1693-1704
12 p.
article
44 Study of ferrous iron oxidation in Morocco drinking water in an airlift reactor El Azher, N.
2008
47 9-10 p. 1877-1886
10 p.
article
45 TMP production scheduling under uncertainty: Methodology and case studies Pulkkinen, Petteri
2008
47 9-10 p. 1492-1503
12 p.
article
46 Two-stage stochastic programming with fixed recourse via scenario planning with economic and operational risk management for petroleum refinery planning under uncertainty Khor, Cheng Seong
2008
47 9-10 p. 1744-1764
21 p.
article
47 Ultrasonic degradation of low-density polyethylene Desai, Vaibhav
2008
47 9-10 p. 1451-1455
5 p.
article
48 Wire mesh tomography applied to trickle beds: A new way to study liquid maldistribution Llamas, Juan-David
2008
47 9-10 p. 1765-1770
6 p.
article
                             48 results found
 
 Koninklijke Bibliotheek - National Library of the Netherlands