nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
A comparative study of wet and dry texturing processes of c-Si wafers for the fabrication of solar cells
|
Moreno, M. |
|
2014 |
101 |
C |
p. 182-191 10 p. |
artikel |
2 |
An investigation of the technoeconomic feasibility of solar domestic hot water heating for the Canadian housing stock
|
Nikoofard, Sara |
|
2014 |
101 |
C |
p. 308-320 13 p. |
artikel |
3 |
A novel linear predictive control approach for auxiliary energy supply to a solar thermal combistorage
|
Pichler, Martin Felix |
|
2014 |
101 |
C |
p. 203-219 17 p. |
artikel |
4 |
A Poisson model for anisotropic solar ramp rate correlations
|
Arias-Castro, Ery |
|
2014 |
101 |
C |
p. 192-202 11 p. |
artikel |
5 |
Application of ZnO micro-flowers as scattering layer for ZnO-based dye-sensitized solar cells with enhanced conversion efficiency
|
Xu, Jinlei |
|
2014 |
101 |
C |
p. 150-159 10 p. |
artikel |
6 |
A simplified model for photovoltaic modules based on improved translation equations
|
Ding, Kun |
|
2014 |
101 |
C |
p. 40-52 13 p. |
artikel |
7 |
Corrosion protection of silver coated reflectors by atomic layer deposited Al2O3
|
Fedel, M. |
|
2014 |
101 |
C |
p. 167-175 9 p. |
artikel |
8 |
Diffusion of Cd vacancy and interstitials of Cd, Cu, Ag, Au and Mo in CdTe: A first principles investigation
|
Roehl, J.L. |
|
2014 |
101 |
C |
p. 245-253 9 p. |
artikel |
9 |
Dynamic performance of water-based radiant floors during start-up and high-intensity solar radiation
|
Zhao, Kang |
|
2014 |
101 |
C |
p. 232-244 13 p. |
artikel |
10 |
Editorial Board
|
|
|
2014 |
101 |
C |
p. ii- 1 p. |
artikel |
11 |
Effect of eccentricity on melting behavior of paraffin in a horizontal tube-in-shell storage unit: An experimental study
|
Yusuf Yazıcı, M. |
|
2014 |
101 |
C |
p. 291-298 8 p. |
artikel |
12 |
Enhanced performance of silicon solar cells by application of low-cost sol–gel-derived Al-rich ZnO film
|
Khan, Firoz |
|
2014 |
101 |
C |
p. 265-271 7 p. |
artikel |
13 |
Enhancement of silicon solar cell efficiency by using back surface field in comparison of different antireflective coatings
|
Ali, Khuram |
|
2014 |
101 |
C |
p. 1-7 7 p. |
artikel |
14 |
Erratum to “Design and optimization of lab-scale sensible heat storage prototype for solar thermal power plant application” [Solar Energy 97 (2013) 217–229]
|
Prasad, Likhendra |
|
2014 |
101 |
C |
p. 28- 1 p. |
artikel |
15 |
Experimental study of a partially heated cavity of an integrated collector storage solar water heater (ICSSWH)
|
Souza, Jeronimo V.D. |
|
2014 |
101 |
C |
p. 53-62 10 p. |
artikel |
16 |
Experimental study of wind effects on unglazed transpired collectors
|
Vasan, Neetha |
|
2014 |
101 |
C |
p. 138-149 12 p. |
artikel |
17 |
Explicit empirical model for general photovoltaic devices: Experimental validation at maximum power point
|
Massi Pavan, A. |
|
2014 |
101 |
C |
p. 105-116 12 p. |
artikel |
18 |
Generalized additive models for nowcasting cloud shading
|
Brabec, Marek |
|
2014 |
101 |
C |
p. 272-282 11 p. |
artikel |
19 |
Graphene-compositing optimization of the properties of dye-sensitized solar cells
|
Fang, Xiaoli |
|
2014 |
101 |
C |
p. 176-181 6 p. |
artikel |
20 |
Hot-spot mitigation in PV arrays with distributed MPPT (DMPPT)
|
Solórzano, J. |
|
2014 |
101 |
C |
p. 131-137 7 p. |
artikel |
21 |
Impact of on-site atmospheric water vapor estimation methods on the accuracy of local solar irradiance predictions
|
Gueymard, Christian A. |
|
2014 |
101 |
C |
p. 74-82 9 p. |
artikel |
22 |
Impact of the heat transfer fluid in a flat plate phase change thermal storage unit for concentrated solar tower plants
|
Liu, Ming |
|
2014 |
101 |
C |
p. 220-231 12 p. |
artikel |
23 |
Improvement of the efficiency and power output of solar cells using nanoparticles and annealing
|
Wang, Xiao-Yu |
|
2014 |
101 |
C |
p. 100-104 5 p. |
artikel |
24 |
Intelligent maximum power point trackers for photovoltaic applications using FPGA chip: A comparative study
|
Chekired, F. |
|
2014 |
101 |
C |
p. 83-99 17 p. |
artikel |
25 |
Methane reforming and water splitting using zirconia-supported cerium oxide in a volumetric receiver–reactor with different types of foam devices
|
Jang, Jong Tak |
|
2014 |
101 |
C |
p. 29-39 11 p. |
artikel |
26 |
Modified incremental conductance MPPT algorithm to mitigate inaccurate responses under fast-changing solar irradiation level
|
Tey, Kok Soon |
|
2014 |
101 |
C |
p. 333-342 10 p. |
artikel |
27 |
Numerical simulation of solar enhanced natural draft dry cooling tower
|
Zou, Zheng |
|
2014 |
101 |
C |
p. 8-18 11 p. |
artikel |
28 |
Optimization of a seasonal storage solar system using Genetic Algorithms
|
Durão, Bruno |
|
2014 |
101 |
C |
p. 160-166 7 p. |
artikel |
29 |
Performance of a V-trough photovoltaic/thermal concentrator
|
Künnemeyer, R. |
|
2014 |
101 |
C |
p. 19-27 9 p. |
artikel |
30 |
Phase change of molten salt during the cold filling of a receiver tube
|
Liao, Zhirong |
|
2014 |
101 |
C |
p. 254-264 11 p. |
artikel |
31 |
Preparation of hydrophobic and abrasion-resistant silica antireflective coatings by using a cationic surfactant to regulate surface morphologies
|
Meng, Xiaoshan |
|
2014 |
101 |
C |
p. 283-290 8 p. |
artikel |
32 |
Solar photocatalytic activity of anatase TiO2 nanocrystals synthesized by non-hydrolitic sol–gel method
|
Leong, Kah Hon |
|
2014 |
101 |
C |
p. 321-332 12 p. |
artikel |
33 |
System analysis of a low-temperature solar process heat system
|
Lauterbach, C. |
|
2014 |
101 |
C |
p. 117-130 14 p. |
artikel |
34 |
The geometric-optics relation between surface slope error and reflected ray error in solar concentrators
|
Lee, Hyunjin |
|
2014 |
101 |
C |
p. 299-307 9 p. |
artikel |
35 |
Three-dimensional SOlar RAdiation Model (SORAM) and its application to 3-D urban planning
|
Erdélyi, Róbert |
|
2014 |
101 |
C |
p. 63-73 11 p. |
artikel |