Digitale Bibliotheek
Sluiten Bladeren door artikelen uit een tijdschrift
 
<< vorige    volgende >>
     Tijdschrift beschrijving
       Alle jaargangen van het bijbehorende tijdschrift
         Alle afleveringen van het bijbehorende jaargang
           Alle artikelen van de bijbehorende aflevering
                                       Details van artikel 2 van 34 gevonden artikelen
 
 
  ANALYSIS, TESTING AND DESIGN OF STEEL ROOF DECK DIAPHRAGMS FOR DUCTILE EARTHQUAKE RESISTANCE
 
 
Titel: ANALYSIS, TESTING AND DESIGN OF STEEL ROOF DECK DIAPHRAGMS FOR DUCTILE EARTHQUAKE RESISTANCE
Auteur: Tremblay, R.
Martin, E.
Yang, W.
Rogers, C. A.
Verschenen in: Journal of earthquake engineering
Paginering: Jaargang 8 (2004) nr. 5 pagina's 775-816
Jaar: 2004-09-01
Inhoud: An experimental program was conducted to study the inelastic response of steel roof deck diaphragms for low-rise steel buildings subjected to seismic loading. Tests were performed on 3.6 m×6.1 m diaphragm specimens made of corrugated steel deck panels. The parameters examined were the thickness and configuration of the sheet steel panels, the type and spacing of the fasteners, the applied loading history and the influence of end lap joints. Diaphragms built with screwed side lap fasteners and nailed deck-to-frame connectors exhibited a pinched hysteretic behaviour, but could sustain large inelastic deformation cycles with limited strength degradation. This type of diaphragm construction could be designed to resist earthquake effects in the inelastic range. Higher shear resistance and less pinching was observed for systems that included welded with washer connections. However, their strength decreased rapidly after the peak load was reached, and hence, these systems should be designed for limited inelastic response. Deck systems with button punched side laps and frame welds without washers showed a brittle response and should be designed to remain elastic under severe earthquake motions. The inelastic demand was found to increase when the spacing of the fasteners was reduced. Specimens constructed with an internal overlap joint exhibited extensive warping of the cross section mainly due to the shorter panel length.
Uitgever: Taylor & Francis
Bronbestand: Elektronische Wetenschappelijke Tijdschriften
 
 

                             Details van artikel 2 van 34 gevonden artikelen
 
<< vorige    volgende >>
 
 Koninklijke Bibliotheek - Nationale Bibliotheek van Nederland