Digitale Bibliotheek
Sluiten Bladeren door artikelen uit een tijdschrift
     Tijdschrift beschrijving
       Alle jaargangen van het bijbehorende tijdschrift
         Alle afleveringen van het bijbehorende jaargang
                                       Alle artikelen van de bijbehorende aflevering
 
                             75 gevonden resultaten
nr titel auteur tijdschrift jaar jaarg. afl. pagina('s) type
1 Adomian decomposition method for Hall and ion-slip effects on mixed convection flow of a chemically reacting Newtonian fluid between parallel plates with heat generation/absorption Reddy, Ch.Ram
2017
4 p. 296-306
artikel
2 Aerodynamic and heat transfer performances of a highly loaded transonic turbine rotor with upstream generic rim seal cavity Mansouri, Zakaria

4 p. 317-331
artikel
3 Analytical analysis of inclined three-layered composite channel with cobalt ferrite nanoparticles and Hall current in Darcy medium Ananth Subray, P.V.

4 p. 523-538
artikel
4 Analytical investigation of laminar flow through expanding or contracting gaps with porous walls Jafaryar, M.
2014
4 p. 222-229
8 p.
artikel
5 Analytical investigation of steady three-dimensional problem of condensation film on inclined rotating disk by Akbari-Ganji's methodAnalytical investigation of steady three-dimensional problem of condensation film on inclined rotating disk by Akbari-Ganji's methodretain--> Berkan, S.
2017
4 p. 277-284
artikel
6 An experimental and theoretical investigation of a small, high aspect-ratio, free-piston, two-stroke engine Lungu, Chiluwata E.

4 p. 326-343
artikel
7 A note on the solution of general Falkner-Skan problem by two novel semi-analytical techniques Khidir, Ahmed
2015
4 p. 212-220
9 p.
artikel
8 A novel approach for suppressing leakage flow through turbine blade tip gaps Wang, Tianyi

4 p. 431-443
artikel
9 Artificial intelligence aided design of film cooling scheme on turbine guide vane Li, Dike

4 p. 344-354
artikel
10 A study of solid ramjet fuel containing boron–magnesium mixtures Sandall, EricT.
2017
4 p. 243-252
artikel
11 Comprehensive rotor service life study for high & intermediate pressure cylinders of high power steam turbines Peshko, V.
2016
4 p. 302-309
8 p.
artikel
12 Convective-radiative fin with temperature dependent thermal conductivity, heat transfer coefficient and wavelength dependent surface emissivity Singh, Surjan
2014
4 p. 207-221
15 p.
artikel
13 Cooling process of liquid propellant rocket by means of kerosene-alumina nanofluid Mahmoodi, Mostafa
2016
4 p. 279-286
8 p.
artikel
14 Defining ecologic thermo-environmental index for aero-engines as a novel performance criterion Şöhret, Yasin

4 p. 374-382
artikel
15 Dynamic interaction between clustered liquid propellant rocket engines under their asynchronous start-ups Dolgopolov, Sergey I.

4 p. 347-359
artikel
16 Effect of asymmetrical wall heat flux and wall temperature ratio on mixed convection in a vertical micro-porous-channel with internal heat generation Leela, V.

4 p. 394-407
artikel
17 Effect of inlet-valve structures on thrust of air-breathing pulse detonation engines Chen, Wenjuan

4 p. 332-346
artikel
18 Effect of windage heating on a micro high-speed rotor-stator cavity Liu, Jianyu

4 p. 496-510
artikel
19 Effects of viscous dissipation and Joule heating on the Couette and Poiseuille flows of a Jeffrey fluid with slip boundary conditions Ramesh, K.
2018
4 p. 329-341
artikel
20 Entropy generation under the influence of radial magnetic field and viscous dissipation of generalized Couette flow in an annulus Yusuf, TaiwoS.
2018
4 p. 342-352
artikel
21 Experimental investigation of performance improving and emissions reducing in a two stroke SI engine by using ethanol additives Ghazikhani, Mohsen
2013
4 p. 276-283
8 p.
artikel
22 Film cooling adiabatic effectiveness measurements of pressure side trailing edge cooling configurations Becchi, R.
2015
4 p. 190-201
12 p.
artikel
23 Finite element analysis on transient magnetohydrodynamic (MHD) free convective chemically reacting micropolar fluid flow past a vertical porous plate with Hall current and viscous dissipation Sheri, SivaReddy
2018
4 p. 353-365
artikel
24 Flow characteristics in a parallel-plate porous channel under convective boundary conditions and triple diffusion for the non-Darcy porous matrix Umavathi, J.C.

4 p. 396-411
artikel
25 Flow dynamics in low aspect ratio dump combustor Yadav, N.P.
2014
4 p. 187-195
9 p.
artikel
26 Flow of micropolar fluid over an off centered rotating disk with modified Darcy's law Khan, N.A.
2017
4 p. 285-295
artikel
27 Full visualization and startup performance of an ammonia pulsating heat pipe Xue, Zhihu
2013
4 p. 263-268
6 p.
artikel
28 Galerkin finite element analysis of magneto-hydrodynamic natural convection of Cu-water nanoliquid in a baffled U-shaped enclosure Zaim, A.

4 p. 383-393
artikel
29 Heat transfer analysis for a free boundary problem arising in n-diffusion equation Dangui-Mbani, UlrichOlivier
2016
4 p. 261-266
6 p.
artikel
30 Heat transfer enhancement from heat sources using optimal design of combined fins heat-sinks Jasim, Hisham H.

4 p. 372-382
artikel
31 Heat transfer optimization and rheological features of Buongiorno nanofluid in a convectively heated inclined annulus with nonlinear thermal radiation Rana, Puneet

4 p. 539-555
artikel
32 Hot-wire experimental investigation on turbulent Prandtl number in a rotating non-isothermal turbulent boundary layer Gao, Ran

4 p. 317-325
artikel
33 Impact of partial slip condition on mixed convection of nanofluid within lid-driven wavy cavity and solid inner body Alsabery, Ammar I.

4 p. 544-564
artikel
34 Inclined magnetic field and variable viscosity effects on bioconvection of Casson nanofluid slip flow over non linearly stretching sheet Sarwar, Noman

4 p. 565-574
artikel
35 Influence of structure parameters on aeroelastic stability for labyrinth seal based on energy method Wang, Nengmao
2018
4 p. 288-295
artikel
36 Influence of temperature dependent heat source/sink on transient MHD free convective flow in an infinite rigid impermeable vertical cylinder with chemical reaction Dwivedi, Naveen

4 p. 568-583
artikel
37 In-service aircraft engines turbine blades life prediction based on multi-modal operation and maintenance data Liu, He

4 p. 360-373
artikel
38 Insights of numerical simulations of magnetohydrodynamic squeezing nanofluid flow through a channel with permeable walls Khan, Kashif Ali

4 p. 412-420
artikel
39 Interplay of non-conducting and conducting walls on magnetohydrodynamic (MHD) natural convection flow in vertical micro-channel in the presence of induced magnetic field Jha, BasantK.
2018
4 p. 296-307
artikel
40 Investigating the effect of blade sweep and lean in one stage of an industrial gas turbine׳s transonic compressor Neshat, M.A.
2015
4 p. 221-229
9 p.
artikel
41 Investigation on experimental load spectrum for high and low cycle combined fatigue test Wang, Rongqiao
2013
4 p. 235-242
8 p.
artikel
42 Magnetohydrodynamic (MHD) boundary layer heat and mass transfer characteristics of nanofluid over a vertical cone under convective boundary condition Reddy, P.Sudarsana
2018
4 p. 308-319
artikel
43 Magnetohydrodynamic (MHD) Jeffrey fluid over a stretching vertical surface in a porous medium Ahmad, Kartini
2017
4 p. 269-276
artikel
44 Magnetohydrodynamic stagnation-point flow of Sisko nanofluid over a stretching sheet with suction Pal, Dulal

4 p. 408-422
artikel
45 Mathematical simulation of low cycle fatigue of high-loaded engine parts Temis, Yury M.
2018
4 p. 277-287
artikel
46 Micropolar fluid flow and heat transfer over an exponentially permeable shrinking sheet Aurangzaib,
2016
4 p. 310-317
8 p.
artikel
47 Model validation and parametric study of fluid flows and heat transfer of aviation kerosene with endothermic pyrolysis at supercritical pressure Xu, Keke
2015
4 p. 202-211
10 p.
artikel
48 N2 and Ar dilution on the premixed biogas jet flame under external acoustic enforcement Alabaş, Buğrahan

4 p. 486-504
artikel
49 Nonlinear radiative heat transfer in magnetohydrodynamic (MHD) stagnation point flow of nanofluid past a stretching sheet with convective boundary condition Ibrahim, Wubshet
2015
4 p. 230-239
10 p.
artikel
50 Non-Newtonian fluid flow in an axisymmetric channel with porous wall Hosseini, M.
2013
4 p. 254-262
9 p.
artikel
51 Numerical investigation of two-dimensional and axisymmetric unsteady flow between parallel plates Raissi, P.
2016
4 p. 318-325
8 p.
artikel
52 Numerical investigation on heat transfer in an advanced new leading edge impingement cooling configuration Lin, G.
2015
4 p. 179-189
11 p.
artikel
53 Numerical investigation to evaluate the effects of gravity and pressure on flame structure and soot formation of turbulent non-premixed methane-air flame Garnayak, Subrat

4 p. 473-495
artikel
54 Numerical simulations of single and multi-staged injection of H2 in a supersonic scramjet combustor Abu-Farah, L.
2014
4 p. 175-186
12 p.
artikel
55 Numerical study for bio-convection effects on MHD nano-fluid flow past a porous and extending wedge Ali, Bagh

4 p. 584-594
artikel
56 Numerical study of effusion cooling on an adiabatic flat plate Hasan, Reaz
2013
4 p. 269-275
7 p.
artikel
57 Numerical study of magnetohydrodynamics (MHD) boundary layer slip flow of a Maxwell nanofluid over an exponentially stretching surface with convective boundary condition Reddy, P.BalaAnki
2017
4 p. 259-268
artikel
58 Numerical study of the effects of split injection strategy and swirl ratio for biodiesel PCCI combustion and emissions Zehni, Alborz

4 p. 355-371
artikel
59 On radiative-magnetoconvective heat and mass transfer of a nanofluid past a non-linear stretching surface with Ohmic heating and convective surface boundary condition Mishra, Shweta
2016
4 p. 326-337
12 p.
artikel
60 Optimization of operating conditions in the steam turbine blade cascade using the black-box method Sadrian, Vahid

4 p. 467-485
artikel
61 Overspeeding characteristics of turbomachinery for gas generator cycle air turbo ramjet engine Minato, Ryojiro

4 p. 444-456
artikel
62 Performance, emissions and exergy analyses of adding CNTs to various biodiesel feedstocks Gad, M.S.

4 p. 511-526
artikel
63 Performance of small-scale aero-derivative industrial gas turbines derived from helicopter engines Nkoi, Barinyima
2013
4 p. 243-253
11 p.
artikel
64 Power and efficiency optimizations for an open cycle two-shaft gas turbine power plant Chen, Lingen

4 p. 457-466
artikel
65 Recent progress in Arrhenius activation energy for radiative heat transport of cross nanofluid over a melting wedge Azam, Muhammad

4 p. 383-395
artikel
66 Significance of thermal stress in a convective-radiative annular fin with magnetic field and heat generation: application of DTM and MRPSM Sowmya, Ganeshappa

4 p. 527-543
artikel
67 Static pressure redistribution mechanism of non-axisymmetric endwall based on radial equilibrium Guo, Hanwen

4 p. 505-522
artikel
68 Stefan blowing effect on bioconvective flow of nanofluid over a solid rotating stretchable disk Latiff, N.A.
2016
4 p. 267-278
12 p.
artikel
69 Strip distortion generator for simulating inlet flow distortion in gas turbine engine ground test facilities Saleem Yusoof, M.
2016
4 p. 287-301
15 p.
artikel
70 Study of abundant explicit wave solutions of the Drinfeld-Sokolov-Satsuma-Hirota (DSSH) equation and the shallow water wave equation Ali, H.M.Shahadat
2018
4 p. 320-328
artikel
71 Study on effects of the secondary fuel manifold unfold pressure on engine starting performance Cai, Jianbing
2017
4 p. 253-258
artikel
72 The azimuthal currents in the ion-driven magnetic nozzle Chen, Zhiyuan

4 p. 457-472
artikel
73 Thermal optimization of MHD nanofluid over a wedge by using response surface methodology: Sensitivity analysis Zeeshan, Ahmed

4 p. 556-567
artikel
74 Vibration behavior optimization of planetary gear sets Shakeri Aski, Farshad
2014
4 p. 196-206
11 p.
artikel
75 What does the future bring? A look at technologies for commercial aircraft in the years 2035–2050 Benzakein, Meyer J.
2014
4 p. 165-174
10 p.
artikel
                             75 gevonden resultaten
 
 Koninklijke Bibliotheek - Nationale Bibliotheek van Nederland