nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
A constitutive numerical modelling of hybrid-based timber beams with partial composite action
|
Tran, T-T. |
|
2018 |
178 |
C |
p. 462-472 |
artikel |
2 |
A multiphase numerical simulation of chloride ions diffusion in concrete using electron microprobe analysis for characterizing properties of ITZ
|
Tian, Ye |
|
2018 |
178 |
C |
p. 432-444 |
artikel |
3 |
Analysis of the feasibility of the use of CDW as a low-environmental-impact aggregate in conglomerates
|
Vidales Barriguete, Alejandra |
|
2018 |
178 |
C |
p. 83-91 |
artikel |
4 |
A prediction approach of concrete properties at early ages by using a thermal stress device
|
Cha, Sang-Lyul |
|
2018 |
178 |
C |
p. 120-134 |
artikel |
5 |
Behavior of meso-scale heterogeneous concrete under uniaxial tensile and compressive loadings
|
Chen, Hongbing |
|
2018 |
178 |
C |
p. 418-431 |
artikel |
6 |
Carbonation resistance of cements containing supplementary cementitious materials and its relation to various parameters of concrete
|
Shah, Vineet |
|
2018 |
178 |
C |
p. 219-232 |
artikel |
7 |
Characterization of EPS lightweight concrete microstructure by X-ray tomography with consideration of thermal variations
|
Maaroufi, Maroua |
|
2018 |
178 |
C |
p. 339-348 |
artikel |
8 |
Combined influence of glass powder and granular steel slag on fresh and mechanical properties of self-compacting concrete
|
Rehman, Shahir |
|
2018 |
178 |
C |
p. 153-160 |
artikel |
9 |
Composition and porosity study of original and restoration materials included in a coastal historical construction
|
Morillas, Héctor |
|
2018 |
178 |
C |
p. 384-392 |
artikel |
10 |
Compressive strength and microstructure of ordinary cured and autoclaved cement-based composites with mechanically activated kaolins
|
Ilić, Biljana |
|
2018 |
178 |
C |
p. 92-101 |
artikel |
11 |
Contribution of Sacrificial Anode in reinforced concrete patch repair: Results of numerical simulations
|
Lozinguez, Eric |
|
2018 |
178 |
C |
p. 405-417 |
artikel |
12 |
Corrosion characteristics of S23043 duplex stainless steel bars
|
Wu, Xun |
|
2018 |
178 |
C |
p. 135-143 |
artikel |
13 |
Design-oriented models for concrete columns confined by steel-reinforced grout jackets
|
Thermou, Georgia E. |
|
2018 |
178 |
C |
p. 313-326 |
artikel |
14 |
Development of non-sintered zero-OPC binders using circulating fluidized bed combustion ash
|
Kang, Yong Hak |
|
2018 |
178 |
C |
p. 562-573 |
artikel |
15 |
Editorial Board
|
|
|
2018 |
178 |
C |
p. ii |
artikel |
16 |
Effect of etched Layered double hydroxides on anti ultraviolet aging properties of bitumen
|
Cao, Zhilong |
|
2018 |
178 |
C |
p. 42-50 |
artikel |
17 |
Effect of MgO on chloride penetration resistance of alkali-activated binder
|
Yoon, H.N. |
|
2018 |
178 |
C |
p. 584-592 |
artikel |
18 |
Effect of recycled coarse aggregate to damping variation of concrete
|
Li, Tan |
|
2018 |
178 |
C |
p. 445-452 |
artikel |
19 |
Effect of the softer binder on the performance of repeated RAP binder
|
He, Hongsen |
|
2018 |
178 |
C |
p. 280-287 |
artikel |
20 |
Effects of additives on the mechanical performance in recycled mixtures with bitumen emulsion: An overview
|
Ayar, Pooyan |
|
2018 |
178 |
C |
p. 551-561 |
artikel |
21 |
Effects of thermal modification on the surface and chemical properties of moso bamboo
|
Lee, Chih-Hsuan |
|
2018 |
178 |
C |
p. 59-71 |
artikel |
22 |
Enhancing mechanical properties of asphalt concrete using synthetic fibers
|
Kim, Min-Jae |
|
2018 |
178 |
C |
p. 233-243 |
artikel |
23 |
Evaluation of pure and mixed modes (I/III) fracture toughness of Portland cement concrete mixtures containing reclaimed asphalt pavement
|
Mansourian, Ahmad |
|
2018 |
178 |
C |
p. 10-18 |
artikel |
24 |
Experimental and numerical study on heating performance of the mass and thin concrete radiant floors with ground source systems
|
Tahersima, Mohammad |
|
2018 |
178 |
C |
p. 360-371 |
artikel |
25 |
Experimental and theoretical analysis of severely damaged concrete beams strengthened with CFRP
|
Kabir, Muhammad Ikramul |
|
2018 |
178 |
C |
p. 161-174 |
artikel |
26 |
Experimental investigation into stressing state characteristics of large-curvature continuous steel box-girder bridge model
|
Shi, Jun |
|
2018 |
178 |
C |
p. 574-583 |
artikel |
27 |
Experimental investigation on static and dynamic mechanical properties of steel fiber reinforced ultra-high-strength concretes
|
Jin, Liu |
|
2018 |
178 |
C |
p. 102-111 |
artikel |
28 |
Experimental study on the compressive and flexural behaviour of recycled aggregate concrete modified with silica fume and fibres
|
Xie, Jianhe |
|
2018 |
178 |
C |
p. 612-623 |
artikel |
29 |
Formation of lubricating layer and flow type during pumping of cement-based materials
|
Secrieru, Egor |
|
2018 |
178 |
C |
p. 507-517 |
artikel |
30 |
Fresh-state performance of recycled aggregate concrete: A review
|
Silva, R.V. |
|
2018 |
178 |
C |
p. 19-31 |
artikel |
31 |
Improvement of high modulus asphalt mixtures with average quality aggregate and bitumen by application of polymeric additives
|
Ranieri, M. |
|
2018 |
178 |
C |
p. 183-194 |
artikel |
32 |
Improvement of mechanical behavior of cemented soil reinforced with waste cornsilk fibers
|
Tran, Khiem Quang |
|
2018 |
178 |
C |
p. 204-210 |
artikel |
33 |
Improving flexural characteristics of 3D printed geopolymer composites with in-process steel cable reinforcement
|
Lim, Jian Hui |
|
2018 |
178 |
C |
p. 32-41 |
artikel |
34 |
Induced heating-healing characterization of activated carbon modified asphalt concrete under microwave radiation
|
Karimi, Mohammad M. |
|
2018 |
178 |
C |
p. 254-271 |
artikel |
35 |
Influence of red mud on fresh and hardened properties of self-compacting concrete
|
Tang, W.C. |
|
2018 |
178 |
C |
p. 288-300 |
artikel |
36 |
In-plane behaviour of unreinforced masonry panel strengthened with welded wire mesh and mortar
|
Shermi, C. |
|
2018 |
178 |
C |
p. 195-203 |
artikel |
37 |
Investigation of microscopic air void structure of anti-freezing asphalt pavement with X-ray CT and MIP
|
Wu, Shuyin |
|
2018 |
178 |
C |
p. 473-483 |
artikel |
38 |
Metakaolin-based geopolymer mortars with different alkaline activators (Na+ and K+)
|
Rocha, Thais da Silva |
|
2018 |
178 |
C |
p. 453-461 |
artikel |
39 |
Modeling and experimental study of multiple factors on mechanical strength of iron sand modified cement mortars
|
Liu, Kai |
|
2018 |
178 |
C |
p. 144-152 |
artikel |
40 |
Numerical evaluation of blast resistance of RC slab strengthened with AFRP
|
Kong, Xiangqing |
|
2018 |
178 |
C |
p. 244-253 |
artikel |
41 |
Olive-stone biomass ash (OBA): An alternative alkaline source for the blast furnace slag activation
|
de Moraes Pinheiro, Sayonara Maria |
|
2018 |
178 |
C |
p. 327-338 |
artikel |
42 |
Optimization of heat cured fly ash/slag blend geopolymer mortars designed by “Combined Design” method: Part 1
|
Luga, Erion |
|
2018 |
178 |
C |
p. 393-404 |
artikel |
43 |
Permanent deformation behaviour of pavement base and subbase containing recycle concrete aggregate, coarse and fine crumb rubber
|
Saberian, Mohammad |
|
2018 |
178 |
C |
p. 51-58 |
artikel |
44 |
Quick heating method of asphalt pavement in hot in-place recycling
|
Xu, Xinxin |
|
2018 |
178 |
C |
p. 211-218 |
artikel |
45 |
Retardation effect of elevated temperature on the setting of calcium sulfoaluminate cement clinker
|
Xu, Linglin |
|
2018 |
178 |
C |
p. 112-119 |
artikel |
46 |
Rheology and thermal stability of polymer modified bitumen with coexistence of amorphous phase and crystalline phase
|
Xia, Tian |
|
2018 |
178 |
C |
p. 272-279 |
artikel |
47 |
Shear performance of recycled aggregate concrete beams: An insight for design aspects
|
Pradhan, Subhasis |
|
2018 |
178 |
C |
p. 593-611 |
artikel |
48 |
Study on the effective composition of steel slag for asphalt mixture induction heating purpose
|
Wan, Jiuming |
|
2018 |
178 |
C |
p. 542-550 |
artikel |
49 |
Supplemental use of rice husk ash (RHA) as a cementitious material in concrete industry
|
Ahsan, Mohammad Badrul |
|
2018 |
178 |
C |
p. 1-9 |
artikel |
50 |
Temperature responses of asphalt mixture physical and finite element models constructed with phase change material
|
Si, Wei |
|
2018 |
178 |
C |
p. 529-541 |
artikel |
51 |
Tensile fatigue behavior of fiber-reinforced cementitious material with high ductility: Experimental study and novel P-S-N model
|
Huang, Bo-Tao |
|
2018 |
178 |
C |
p. 349-359 |
artikel |
52 |
The effects of PE and PVA fiber and water cement ratio on chloride penetration and rebar corrosion protection performance of cracked SHCC
|
Kobayashi, Koichi |
|
2018 |
178 |
C |
p. 372-383 |
artikel |
53 |
The influence of addition of treated kenaf fibre in the production and properties of fibre reinforced foamed composite
|
Mahzabin, Mst. Sadia |
|
2018 |
178 |
C |
p. 518-528 |
artikel |
54 |
The mechanical and durability properties of concrete containing hybrid synthetic fibers
|
Sadrinejad, Iman |
|
2018 |
178 |
C |
p. 72-82 |
artikel |
55 |
Ultra-high performance fibre-reinforced cementitious composite with steel microfibres functionalized with silane
|
Casagrande, Cézar Augusto |
|
2018 |
178 |
C |
p. 495-506 |
artikel |
56 |
Understanding the effects of hooked-end steel fibre geometry on the uniaxial tensile behaviour of self-compacting concrete
|
Abdallah, Sadoon |
|
2018 |
178 |
C |
p. 484-494 |
artikel |
57 |
Understanding variability in recycled aggregate concrete mechanical properties through numerical simulation and statistical evaluation
|
Jayasuriya, Anuruddha |
|
2018 |
178 |
C |
p. 301-312 |
artikel |
58 |
Utilization of municipal solid waste incineration bottom ash in autoclaved aerated concrete
|
Li, XiangGuo |
|
2018 |
178 |
C |
p. 175-182 |
artikel |