Digitale Bibliotheek
Sluiten Bladeren door artikelen uit een tijdschrift
     Tijdschrift beschrijving
       Alle jaargangen van het bijbehorende tijdschrift
         Alle afleveringen van het bijbehorende jaargang
                                       Alle artikelen van de bijbehorende aflevering
 
                             74 gevonden resultaten
nr titel auteur tijdschrift jaar jaarg. afl. pagina('s) type
1 A comparative study of the induction healing behaviors of hot and warm mix asphalt Liu, Quantao
2017
144 C p. 663-670
artikel
2 Acoustic emission monitoring and damage assessment of FRP-strengthened reinforced concrete columns under cyclic loading Ma, Gao
2017
144 C p. 86-98
artikel
3 Analytical and genetic programming model of compressive strength of eco concretes by NDT according to curing temperature Velay-Lizancos, Mirian
2017
144 C p. 195-206
artikel
4 An environmentally friendly method to improve the quality of recycled concrete aggregates Wang, Liang
2017
144 C p. 432-441
artikel
5 An experimental study of different curing regimes on the mechanical properties and sorptivity of self-compacting mortars with fly ash and silica fume Benli, Ahmet
2017
144 C p. 552-562
artikel
6 A novel electrochemical technique for enhancing silane penetration depth into mortar Shan, Hongyou
2017
144 C p. 645-649
artikel
7 A self-powered surface sensing approach for detection of bottom-up cracking in asphalt concrete pavements: Theoretical/numerical modeling Hasni, Hassene
2017
144 C p. 728-746
artikel
8 A study on moisture susceptibility of stone matrix warm mix asphalt Khedmati, M.
2017
144 C p. 42-49
artikel
9 Bond strength characterization of commercially available grouts for masonry Luso, Eduarda
2017
144 C p. 317-326
artikel
10 Can nanosilica sol prevent oil well cement from strength retrogression under high temperature? Wang, Chengwen
2017
144 C p. 574-585
artikel
11 Carbonation-induced volume change in alkali-activated slag Ye, Hailong
2017
144 C p. 635-644
artikel
12 Characterization of the rutting potential of modified asphalt binders and its correlation with the mixture’s rut resistance Domingos, Matheus David Inocente
2017
144 C p. 207-213
artikel
13 Comparative investigation on influences of concrete material constitutive models on structural behavior Wang, Yu-Hang
2017
144 C p. 475-483
artikel
14 Determining the engineering characteristics of the Hi-FA series of grout materials in an underwater condition Song, Byeong-Deok
2017
144 C p. 74-85
artikel
15 Development of physical and mechanical properties of a cold-curing structural adhesive in a wet bridge environment Savvilotidou, M.
2017
144 C p. 115-124
artikel
16 Dynamic simulation of unrestrained interlocking Tuned Liquid Damper blocks Ong, Peng Pheng
2017
144 C p. 586-597
artikel
17 Editorial Board 2017
144 C p. IFC
artikel
18 Effect of competitive adsorption between sodium gluconate and polycarboxylate superplasticizer on rheology of cement paste Tan, Hongbo
2017
144 C p. 338-346
artikel
19 Effect of fly ash on the pore structure of cement paste under a curing period of 3years Yu, Zhuqing
2017
144 C p. 493-501
artikel
20 Effect of glycerol introduced into PLA based composites on the UV weathering behavior Lv, Shanshan
2017
144 C p. 525-531
artikel
21 Effect of particles with different mechanical properties on the energy dissipation properties of concrete Lu, Song
2017
144 C p. 502-515
artikel
22 Effect of sugar cane straw ash (SCSA) as solid precursor and the alkaline activator composition on alkali-activated binders based on blast furnace slag (BFS) Moraes, J.C.B.
2017
144 C p. 214-224
artikel
23 Effect of wetting–drying cycles on compressive strength and microstructure of recycled asphalt pavement – Fly ash geopolymer Hoy, Menglim
2017
144 C p. 624-634
artikel
24 Effects of ambient temperature and relative humidity on early-age shrinkage of UHPC with high-volume mineral admixtures Yalçınkaya, Çağlar
2017
144 C p. 252-259
artikel
25 Effects of self-healing cracks in bacterial concrete on the transmission of chloride during electromigration Ling, Hao
2017
144 C p. 406-411
artikel
26 Enhanced entrainment of fine air bubbles in self-compacting concrete with high volume of fly ash using defoaming agent for improved entrained air stability and higher aggregate content Puthipad, Nipat
2017
144 C p. 1-12
artikel
27 Estimation of ice formation in mortar saturated with sodium chloride solutions Wang, Yi
2017
144 C p. 238-251
artikel
28 Evaluation of moisture susceptibility of asphalt mixture using liquid anti-stripping agents Park, Dae-Wook
2017
144 C p. 399-405
artikel
29 Evaluation of spent diatomite incorporation in clay based materials for lightweight bricks processing Galán-Arboledas, R.J.
2017
144 C p. 327-337
artikel
30 Evaluation of the influence of a superplasticizer on the hydration of varying composition cements by the electrical resistivity measurement method Yousuf, Farqad
2017
144 C p. 25-34
artikel
31 Experimental impact analysis on ultra-high performance concrete (UHPC) for achieving stress equilibrium (SE) and constant strain rate (CSR) in Split Hopkinson pressure bar (SHPB) using pulse shaping technique Hassan, Mostafa
2017
144 C p. 747-757
artikel
32 Experimental investigation of composite beams reinforced with GFRP I-beam and steel bars Hadi, Muhammad N.S.
2017
144 C p. 462-474
artikel
33 Factors affecting bond development between Ultra High Performance Concrete (UHPC) and steel bar reinforcement Alkaysi, Mo
2017
144 C p. 412-422
artikel
34 Flexural behavior of stone slabs strengthened with reinforced mortar Guo, Zi-Xiong
2017
144 C p. 158-167
artikel
35 Formulation and characterization of blended alkali-activated materials based on flash-calcined metakaolin, fly ash and GGBS Samson, Gabriel
2017
144 C p. 50-64
artikel
36 High performance concrete incorporating ceramic waste powder as large partial replacement of Portland cement Kannan, Dima M.
2017
144 C p. 35-41
artikel
37 High temperature performance of SBS modified bio-asphalt Zhang, Ran
2017
144 C p. 99-105
artikel
38 Improved mechanical properties and piezoresistive sensitivity evaluation of MWCNTs reinforced cement mortars Jeevanagoudar, Yashavant V
2017
144 C p. 188-194
artikel
39 Influence of rheological properties of cement mortar on steel fiber distribution in UHPC Wang, Rui
2017
144 C p. 65-73
artikel
40 Influence of source materials and the role of oxide composition on the performance of ternary blended sustainable geopolymer mortar Sharmin, Afia
2017
144 C p. 608-623
artikel
41 Influence of temperature history on chloride diffusion in high volume fly ash concrete Jiang, Peng
2017
144 C p. 677-685
artikel
42 Influence of the initial moist curing time on the sulfate attack resistance of concretes with different binders Zhang, Zengqi
2017
144 C p. 541-551
artikel
43 Influence of water to cement ratio on the efficiency of internal curing of high-performance concrete Zhutovsky, Semion
2017
144 C p. 311-316
artikel
44 Investigation of effects of Portland cement fineness and alkali content on concrete plastic shrinkage cracking Yang, Kai
2017
144 C p. 279-290
artikel
45 Investigation on electrically conductive aggregates produced by incorporating carbon fiber and carbon black Chen, Binmeng
2017
144 C p. 106-114
artikel
46 Investigation on physical and high temperature rheology properties of asphalt binder adding waste oil and polymers Luo, Weihua
2017
144 C p. 13-24
artikel
47 Laboratory Assessment of Hybrid Fiber and Nano-silica on Reinforced Porous Asphalt Mixtures Tanzadeh, Javad
2017
144 C p. 260-270
artikel
48 Laboratory investigation and numerical simulation of the rutting performance of double-layer surfacing structure for steel bridge decks Luo, Sang
2017
144 C p. 178-187
artikel
49 Long-term durability testing on the MgO-activated slag cured in brine Pan, Yang
2017
144 C p. 271-278
artikel
50 Mechanical and thermal properties of concrete incorporating rubber and fibres from tyre recycling Medina, Nelson Flores
2017
144 C p. 563-573
artikel
51 Mechanical properties of the concrete containing recycled fibers and aggregates Ahmadi, Mohsen
2017
144 C p. 392-398
artikel
52 Mechanism of cement on the performance of cement stabilized aggregate for high speed railway roadbed Guotang, Zhao
2017
144 C p. 347-356
artikel
53 Mesoscale simulation of fatigue behavior of concrete materials damaged by freeze-thaw cycles Gong, Fuyuan
2017
144 C p. 702-716
artikel
54 Modification of traditional Chinese ginger nut and its mechanical behavior Chen, Weichang
2017
144 C p. 138-146
artikel
55 Optimization of alkali-activated mortar utilizing ground granulated blast-furnace slag and natural pozzolan from Germany with the dynamic approach of the Taguchi method Onoue, Kozo
2017
144 C p. 357-372
artikel
56 Optimizing the mixing procedure of warm asphalt rubber with wax-based additives through mechanism investigation and performance characterization Leng, Zhen
2017
144 C p. 291-299
artikel
57 Photocatalytic behavior of colored mortars containing TiO2 and iron oxide based pigments Laplaza, A.
2017
144 C p. 300-310
artikel
58 Prediction model for relative humidity of early-age internally cured concrete with pre-wetted lightweight aggregates Shen, Dejian
2017
144 C p. 717-727
artikel
59 Properties of hardener-free epoxy-modified mortars utilizing pyrolysis tar replacement Kim, Wan-Ki
2017
144 C p. 598-607
artikel
60 Pull-out behavior of straight steel fibers from asphalt binder Park, Philip
2017
144 C p. 125-137
artikel
61 Recent research on cold-formed steel beams and columns subjected to elevated temperature: A review Javed, Muhammad Faisal
2017
144 C p. 686-701
artikel
62 Rehydration on heat-treated cementitious materials up to 700°C-coupled transport properties characterization Pei, Yan
2017
144 C p. 650-662
artikel
63 Response of hygroscopicity to heat treatment and its relation to durability of thermally modified wood Li, Tao
2017
144 C p. 671-676
artikel
64 Rheological characteristics of alternative modified binders Liu, Lingqing
2017
144 C p. 442-450
artikel
65 Significance of performance based specifications in the qualification and characterization of blended cement using volcanic ash Al-Fadala, S.
2017
144 C p. 532-540
artikel
66 Small and large strain rheological characterizations of polymer- and crumb rubber-modified asphalt binders Diab, Aboelkasim
2017
144 C p. 168-177
artikel
67 Study of the volume stability of slag cement mortar applied to desulfurization slag during high temperature operation Ho, Chun-Ling
2017
144 C p. 147-157
artikel
68 Study on concrete pumpability combining different laboratory tools and linkage to rheology Secrieru, Egor
2017
144 C p. 451-461
artikel
69 Study on the properties of artificial flood-prevention stone made by Yellow River silt Wang, Baomin
2017
144 C p. 484-492
artikel
70 Superhydrophobic rice husk ash coating on concrete Husni, H.
2017
144 C p. 385-391
artikel
71 Synergetic effect of multi-dimensional nanomaterials for anti-aging properties of SBS modified bitumen Zhang, Dongmei
2017
144 C p. 423-431
artikel
72 Test and numerical simulation of large angle wedge type of anchorage using transverse enhanced CFRP tendons for beam string structure Han, Qinghua
2017
144 C p. 225-237
artikel
73 The hydration mechanism and performance of Modified magnesium oxysulfate cement by tartaric acid Wu, Chengyou
2017
144 C p. 516-524
artikel
74 Utilization of fly ash cenosphere as lightweight filler in cement-based composites – A review Hanif, Asad
2017
144 C p. 373-384
artikel
                             74 gevonden resultaten
 
 Koninklijke Bibliotheek - Nationale Bibliotheek van Nederland