Digitale Bibliotheek
Sluiten Bladeren door artikelen uit een tijdschrift
     Tijdschrift beschrijving
       Alle jaargangen van het bijbehorende tijdschrift
         Alle afleveringen van het bijbehorende jaargang
                                       Alle artikelen van de bijbehorende aflevering
 
                             60 gevonden resultaten
nr titel auteur tijdschrift jaar jaarg. afl. pagina('s) type
1 A meso-macro numerical approach for crack-induced diffusivity evolution in concrete Benkemoun, Nathan
2017
141 C p. 72-85
artikel
2 A novel approach for near-surface defect detection in FRP-bonded concrete systems using laser reflection and acoustic-laser techniques Qiu, Qiwen
2017
141 C p. 553-564
artikel
3 Assessing benefits of pre-soaked recycled concrete aggregate on variably cured concrete Pickel, Daniel
2017
141 C p. 245-252
artikel
4 Assessment of Greener Cement by employing thermally treated sugarcane straw ashes Ferreira, Eduardo Gurzoni Alvares
2017
141 C p. 343-352
artikel
5 Axial compressive behaviour of steel-jacket retrofitted RC columns with recycled aggregate concrete He, An
2017
141 C p. 501-516
artikel
6 Behaviours of reinforced concrete beams under low temperatures Yan, Jia-Bao
2017
141 C p. 410-425
artikel
7 Chloride threshold value to initiate reinforcement corrosion in simulated concrete pore solutions: The influence of surface finishing and pH Figueira, Rita B.
2017
141 C p. 183-200
artikel
8 Comparison of environmental benchmarks of masonry and concrete structure based on a building model Sazedj, Soheyl
2017
141 C p. 36-43
artikel
9 Comparison of the Saturated Salt Solution and the Dynamic Vapor Sorption techniques based on the measured sorption isotherm of barley straw Bui, Rudy
2017
141 C p. 140-151
artikel
10 Compressive behavior of steel fiber reinforced recycled coarse aggregate concrete designed with equivalent cubic compressive strength Gao, Danying
2017
141 C p. 235-244
artikel
11 Computational homogenization for thermal conduction in heterogeneous concrete after mechanical stress Jin, Liu
2017
141 C p. 222-234
artikel
12 Deformation of concrete under high-cycle fatigue loads in uniaxial and eccentric compression Jiang, Chao
2017
141 C p. 379-392
artikel
13 Development and performance of sand fog seal with cooling and air purification effects Guo, Tengteng
2017
141 C p. 608-618
artikel
14 Editorial Board 2017
141 C p. IFC
artikel
15 Effect of fiber content variation on the strength of the weakest section in Strain Hardening Cementitious Composites (SHCC) Lu, Cong
2017
141 C p. 253-258
artikel
16 Effect of ground granulated blast furnace slag (GGBFS) on RCCP durability Aghaeipour, Arash
2017
141 C p. 533-541
artikel
17 Effect of high temperature on the bond performance between basalt fibre reinforced polymer (BFRP) bars and concrete Li, Chenchen
2017
141 C p. 44-51
artikel
18 Effect of mineral fillers adsorption on rheological and chemical properties of asphalt binder Guo, Meng
2017
141 C p. 152-159
artikel
19 Effect of Na3PO4 inhibitor on chloride diffusion in mortar Nahali, H.
2017
141 C p. 589-597
artikel
20 Effect of tack coat dosage and temperature on the interface shear properties of asphalt layers bonded with emulsified asphalt binders Hu, Xiaodi
2017
141 C p. 86-93
artikel
21 Effect of triethanolamine on cement hydration toward initial setting time Yaphary, Yohannes L.
2017
141 C p. 94-103
artikel
22 Effects of phosphorus slag powder and polyester fiber on performance characteristics of asphalt binders and resultant mixtures Sheng, Yanping
2017
141 C p. 289-295
artikel
23 Evaluation of wearing course mix designs on sound absorption improvement of porous asphalt pavement Chu, L.
2017
141 C p. 402-409
artikel
24 Experimental results on the retrofitting of hollow brick masonry walls with reinforced high performance mortar coatings Messali, F.
2017
141 C p. 619-630
artikel
25 Experimental study on fly ash and lead smelter slag-based geopolymer concrete columns Albitar, M.
2017
141 C p. 104-112
artikel
26 Finite element modeling and parametric analysis of viscoelastic and nonlinear pavement responses under dynamic FWD loading Li, Maoyun
2017
141 C p. 23-35
artikel
27 Fired hollow clay bricks manufactured from black cotton soils and natural pozzolans in Kenya Zhang, Peiping
2017
141 C p. 435-441
artikel
28 Geopolymer matrix for fibre reinforced composites aimed at strengthening masonry structures Tamburini, Sergio
2017
141 C p. 542-552
artikel
29 Hardened behavior of mortar based on recycled aggregate: Influence of saturation state at macro- and microscopic scales Le, Thang
2017
141 C p. 479-490
artikel
30 High performance cold asphalt concrete mixture for binder course using alkali-activated binary blended cementitious filler Dulaimi, Anmar
2017
141 C p. 160-170
artikel
31 Impact of a reinforcement treatment with acrylate impregnation on the mechanical behavior of black spruce as connector member Lafond, C.
2017
141 C p. 517-525
artikel
32 Influence of early water exposure on modified cementitious coating Al-Kheetan, Mazen J.
2017
141 C p. 64-71
artikel
33 Influence of mixing method, speed and duration on the fresh and hardened properties of Reactive Powder Concrete Hiremath, Parameshwar N.
2017
141 C p. 271-288
artikel
34 Investigation of fatigue cracks on RAP mixtures containing Sasobit and crumb rubber based on fracture energy Behroozikhah, Abdolhamid
2017
141 C p. 526-532
artikel
35 Investigation of rutting, fracture and thermal cracking behavior of asphalt mastic containing basalt and hydrated lime fillers Das, Aditya Kumar
2017
141 C p. 442-452
artikel
36 Investigation of waste ceramic tile additive in hot mix asphalt using fuzzy logic approach Kara, Çağdaş
2017
141 C p. 598-607
artikel
37 Mechanical behaviour of a polyvinyl alcohol fibre reinforced engineered cementitious composite (PVA-ECC) using local ingredients Meng, Dan
2017
141 C p. 259-270
artikel
38 Microbiologically induced calcium carbonate precipitation to repair microcracks remaining after autogenous healing of mortars Lors, C.
2017
141 C p. 461-469
artikel
39 Optimization in producing warm mix asphalt with polymer modified binder and surfactant-wax additive Golchin, Babak
2017
141 C p. 578-588
artikel
40 Packing density and surface finishing condition effects on the mechanical properties of various concrete pavements containing cement replacement admixtures Shirzadi Javid, Ali Akbar
2017
141 C p. 307-314
artikel
41 Parameter estimation for nonlinear analysis of multi-perforated concrete masonry walls Lizárraga, José F.
2017
141 C p. 353-365
artikel
42 Performance characteristics of Terminal Blend rubberized asphalt with SBS and polyphosphoric acid Lin, Peng
2017
141 C p. 171-182
artikel
43 Potential of finely ground limestone powder to benefit ultra-high performance concrete mixtures Burroughs, Jedadiah F.
2017
141 C p. 335-342
artikel
44 Prediction and evaluation of density and volume fractions for the novel perlite composite affected by internal structure formation Arifuzzaman, Md
2017
141 C p. 201-215
artikel
45 Properties and modification mechanisms of nano-zirconia filled reactive powder concrete Han, Baoguo
2017
141 C p. 426-434
artikel
46 Quantitative measurement of the influence of degree of saturation on ion penetration in cement paste by using X-ray imaging Khanzadeh Moradllo, Mehdi
2017
141 C p. 113-129
artikel
47 Reliability analysis of adhesively bonded CFRP-to-steel double lap shear joint with thin outer adherends Liu, Meng
2017
141 C p. 52-63
artikel
48 Research on cement hydration and hardening with different alkanolamines Xu, Zhiqiang
2017
141 C p. 296-306
artikel
49 Self-healing efficiency of ferrite-filled asphalt mixture after microwave irradiation Zhu, Xingyi
2017
141 C p. 12-22
artikel
50 Stepwise regression modeling for compressive strength of alkali-activated concrete Thomas, R.J.
2017
141 C p. 315-324
artikel
51 Strength of circular HSC columns reinforced internally with carbon-fiber-reinforced polymer bars under axial and eccentric loads Hadhood, Abdeldayem
2017
141 C p. 366-378
artikel
52 Strength, permeability and micro-structural characteristics of low-calcium fly ash based geopolymers Mehta, Ankur
2017
141 C p. 325-334
artikel
53 Study on the micro-crack evolution of concrete subjected to stress corrosion and magnesium sulfate Tan, Yongshan
2017
141 C p. 453-460
artikel
54 Superhydrophobic coatings on Portland cement concrete surfaces Arabzadeh, Ali
2017
141 C p. 393-401
artikel
55 Surface-wave attenuation zone of layered periodic structures and feasible application in ground vibration reduction Huang, Jiankun
2017
141 C p. 1-11
artikel
56 Synthesis reaction and compressive strength behavior of loess-fly ash based geopolymers for the development of sustainable green materials Dassekpo , Jean-Baptiste Mawulé
2017
141 C p. 491-500
artikel
57 The effect of seawater curing on properties of magnesium potassium phosphate cement Yang, Jianming
2017
141 C p. 470-478
artikel
58 Use of carbonate precipitating bacteria to reduce water absorption of aggregates Hosseini Balam, Nafise
2017
141 C p. 565-577
artikel
59 Utilization of air-launched ground penetrating radar (GPR) for pavement condition assessment Khamzin, Aleksey K.
2017
141 C p. 130-139
artikel
60 Water vapour diffusion resistance factor of Phyllostachys edulis (Moso bamboo) Huang, Puxi
2017
141 C p. 216-221
artikel
                             60 gevonden resultaten
 
 Koninklijke Bibliotheek - Nationale Bibliotheek van Nederland