nr |
titel |
auteur |
tijdschrift |
jaar |
jaarg. |
afl. |
pagina('s) |
type |
1 |
Adsorption and desorption of binary mixture of acetone and ethyl acetate on silica gel
|
Sui, Hong |
|
2019 |
197 |
C |
p. 185-194 |
artikel |
2 |
Adsorption and structure of benzene, toluene, and p-xylene in carbon slit pores: A Monte Carlo simulation study
|
Diao, Rui |
|
2019 |
197 |
C |
p. 120-134 |
artikel |
3 |
Analysis of pneumatic nozzle operation with the stochastic Euler-Lagrange model
|
Ludwig, Wojciech |
|
2019 |
197 |
C |
p. 386-403 |
artikel |
4 |
An Euler-Euler model for mono-dispersed gas-particle flows incorporating electrostatic charging due to particle-wall and particle-particle collisions
|
Ray, M. |
|
2019 |
197 |
C |
p. 327-344 |
artikel |
5 |
An evaluation of in-silico methods for predicting solute partition in multiphase complex fluids – A case study of octanol/water partition coefficient
|
Turchi, Mattia |
|
2019 |
197 |
C |
p. 150-158 |
artikel |
6 |
Breakup dynamics of droplets in an asymmetric bifurcation by μPIV and theoretical investigations
|
Wang, Xiang |
|
2019 |
197 |
C |
p. 258-268 |
artikel |
7 |
CFD analysis of fluid flow and particle-to-fluid heat transfer in packed bed with radial layered configuration
|
Guo, Zehua |
|
2019 |
197 |
C |
p. 357-370 |
artikel |
8 |
CFD-DEM simulation of heat transfer in fluidized beds: Model verification, validation, and application
|
Wang, Shuai |
|
2019 |
197 |
C |
p. 280-295 |
artikel |
9 |
Corrigendum to “Measurements of hydrocarbon bubble points in synthesized mesoporous siliceous monoliths” [Chem. Eng. Sci. 177 (2018) 481–490]
|
Cho, Hyeyoung |
|
2019 |
197 |
C |
p. 184 |
artikel |
10 |
Corrigendum to “Mesoscale modeling of emulsification in rotor–stator devices: Part I: A population balance model based on EMMS concept” [Chem. Eng. Sci. 193 (2019) 171–183]
|
Chen, Chao |
|
2019 |
197 |
C |
p. 419 |
artikel |
11 |
Corrigendum to “Mesoscale modeling of emulsification in rotor–stator devices: Part II: A model framework integrating emulsifier adsorption” [Chem. Eng. Sci. 193 (2019) 156–170]
|
Chen, Chao |
|
2019 |
197 |
C |
p. 326 |
artikel |
12 |
Defect-engineered cobalt-based solid catalyst for high efficiency oxidation of sulfite
|
Liu, Jie |
|
2019 |
197 |
C |
p. 1-10 |
artikel |
13 |
Editorial Board
|
|
|
2019 |
197 |
C |
p. ii |
artikel |
14 |
Effect of surface tension, viscosity, pore geometry and pore contact angle on effective pore throat
|
Chao, Cong |
|
2019 |
197 |
C |
p. 269-279 |
artikel |
15 |
Enhanced oil recovery with CO2/N2 slug in low permeability reservoir: Molecular dynamics simulation
|
Fang, Timing |
|
2019 |
197 |
C |
p. 204-211 |
artikel |
16 |
Evaluation the effect of fiber alignment on particle collection performance of mechanical/electret filters based on Voronoi tessellations
|
Cai, Rong-Rong |
|
2019 |
197 |
C |
p. 109-119 |
artikel |
17 |
Extrapolation of DEM simulations to large time scale. Application to the mixing of powder in a conical screw mixer
|
Bednarek, X. |
|
2019 |
197 |
C |
p. 223-234 |
artikel |
18 |
Fractal continuum model for the adsorption-diffusion process
|
Herrera-Hernández, E.C. |
|
2019 |
197 |
C |
p. 98-108 |
artikel |
19 |
Gas flow maldistribution in random packed beds of non-spherical particles – A CFD study
|
Marek, M. |
|
2019 |
197 |
C |
p. 296-305 |
artikel |
20 |
Global optimization of distillation columns using explicit and implicit surrogate models
|
Keßler, Tobias |
|
2019 |
197 |
C |
p. 235-245 |
artikel |
21 |
Influence of the inclination of a plate on forces generated in flows of Newtonian and yield stress fluids
|
Ouattara, Ziemihori |
|
2019 |
197 |
C |
p. 246-257 |
artikel |
22 |
Investigation of a novel photoelectrochemical hydrogen production system
|
Acar, Canan |
|
2019 |
197 |
C |
p. 74-86 |
artikel |
23 |
Mathematical modelling of surface tension of nanoparticles in electrolyte solutions
|
Olayiwola, Saheed Olawale |
|
2019 |
197 |
C |
p. 345-356 |
artikel |
24 |
Mechanism of small bubble breakup in an unbaffled stirred vessel
|
Yamamoto, Takuya |
|
2019 |
197 |
C |
p. 26-36 |
artikel |
25 |
Method for recovery of complete molecular composition of the Fischer-Tropsch synthesis products on the basis of incomplete experimental data
|
Ermolaev, Vadim S. |
|
2019 |
197 |
C |
p. 317-325 |
artikel |
26 |
Microkinetic modeling of aqueous phase biomass conversion: Application to ethylene glycol reforming
|
Gu, Geun Ho |
|
2019 |
197 |
C |
p. 415-418 |
artikel |
27 |
Miniaturization of surface patterns in soft elastic film over patterned substrates
|
Basu, Surita |
|
2019 |
197 |
C |
p. 195-203 |
artikel |
28 |
Modeling the electrocoagulation process for the treatment of contaminated water
|
Graça, Nuno S. |
|
2019 |
197 |
C |
p. 379-385 |
artikel |
29 |
Modelling bubble induced turbulence for gas-liquid bubbly flow in a vertical pipe
|
Islam, A.S.M. Atiqul |
|
2019 |
197 |
C |
p. 159-171 |
artikel |
30 |
Novel chromatographic process for the recovery and purification of hydroxy acids from alkaline spent pulping liquors
|
Heinonen, Jari |
|
2019 |
197 |
C |
p. 87-97 |
artikel |
31 |
Numerical simulation of milk fouling: Taking fouling layer domain and localized surface reaction kinetics into account
|
Pan, Fei |
|
2019 |
197 |
C |
p. 306-316 |
artikel |
32 |
Oligomerization of supercritical ethylene over nickel-based silica-alumina catalysts
|
Jan, Oliver |
|
2019 |
197 |
C |
p. 212-222 |
artikel |
33 |
Oxygen content as a variable to control product selectivity in hydrodeoxygenation reactions on molybdenum carbide catalysts
|
Kumar, Anurag |
|
2019 |
197 |
C |
p. 371-378 |
artikel |
34 |
Parameter estimation in reactive systems subject to sufficient criteria for thermodynamic stability
|
Glass, Moll |
|
2019 |
197 |
C |
p. 420-431 |
artikel |
35 |
Pore scale and macroscopic visual displacement of oil-in-water emulsions for enhanced oil recovery
|
Liu, Zheyu |
|
2019 |
197 |
C |
p. 404-414 |
artikel |
36 |
Production of polyamide 11 microparticles for Additive Manufacturing by liquid-liquid phase separation and precipitation
|
Dechet, Maximilian A. |
|
2019 |
197 |
C |
p. 11-25 |
artikel |
37 |
Simulation of plasma-assisted catalytic reduction of NOx, CO, and HC from diesel engine exhaust with COMSOL
|
Oskooei, Araz Belali |
|
2019 |
197 |
C |
p. 135-149 |
artikel |
38 |
Study of droplet breakage in a pulsed disc and doughnut column-Part I: Experiments and correlations
|
Zhou, Hao |
|
2019 |
197 |
C |
p. 172-183 |
artikel |
39 |
Supported Mn catalysts and the role of different supports in the catalytic oxidation of carbon monoxide
|
Mobini, Sajad |
|
2019 |
197 |
C |
p. 37-51 |
artikel |
40 |
Three-dimensional numerical simulation of gas-liquid interfacial mass transfer with Rayleigh convection using hybrid LBM-FDM and its mass transfer coefficient model
|
Ge, Xiaolong |
|
2019 |
197 |
C |
p. 52-68 |
artikel |
41 |
Topography analysis of particle velocity distribution function in gas-solid flow
|
Zhao, Bidan |
|
2019 |
197 |
C |
p. 69-73 |
artikel |
42 |
Two-step MILP/MINLP approach for the synthesis of large-scale HENs
|
Nemet, Andreja |
|
2019 |
197 |
C |
p. 432-448 |
artikel |